Getting Started - Kenwood KDC-210U Manual De Instrucciones

GETTING STARTED

1
Cancel the demonstration
When you turn on the power (or after you reset the unit), the display
shows: "CANCEL DEMO" \ "PRESS" \ "VOLUME KNOB"
1
Press the volume knob.
[YES] is selected for the initial setup.
2 Press the volume knob again.
"DEMO OFF" appears.
2
Set the clock
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to make a selection (one at a time), then
press the knob.
Selection: [SETTINGS], [CLOCK], [CLOCK ADJ]
2
Repeat step to make the next selection.
3
Turn the volume knob to adjust the clock, then press the knob.
Press 4 / ¢ to move between the hour and minute adjustment.
4
Press and hold to exit.
(or)
Press and hold SCRL DISP to enter clock adjustment mode
directly while the clock time is displayed.
3
Then, perform step above to set the clock.
4
3
Set the initial settings
1
Press SRC to enter [STANDBY].
2
Press the volume knob to enter [FUNCTION].
3 Turn the volume knob to select [INITIAL SET], then press the knob.
4
Turn the volume knob to make a selection (see the following table),
then press the knob.
5 Press and hold to exit.
• To return to the previous hierarchy, press
PRESET TYPE NORM: Memorizes one station for each preset button in each band (FM1/
FM2/ FM3/ AM). ; MIX: Memorizes one station for each preset button,
regardless of the selected band.
KEY BEEP ON: Activates the keypress tone. ; OFF: Deactivates.
PANDORA SRC ON: Enables PANDORA in source selection. ; OFF: Disables. (➜ 8)
BUILTIN AUX ON: Enables AUX in source selection. ; OFF: Disables. (➜ 8)
CD READ 1: Automatically distinguishes between audio file disc and audio CD. ;
2: Forces to play as an audio CD. No sound can be heard if an audio file disc
is played.
SWITCH PRE REAR/ SUB-W: Selects whether rear speakers are connected or a
subwoofer is connected to the line out terminals on the rear (through an
external amplifier).
SP SELECT OFF/ 5/4/ 6 × 9/6/ OEM: Selects according to the speaker size (5 inches
or 4 inches, 6×9 inches or 6 inches) or OEM speakers for optimum
performance.
F/W UPDATE
F/W UP xx.xx YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not
activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
.
Default: XX