Kasanova KWI000016 Manual De Instrucciones página 14

WET&DRY
14
container.
1) Remove the handheld vacuum cleaner from the wall bracket or, if you are
not using the wall bracket remove the barrel plug from the socket.
2) If required, place the appropriate nozzle in the suction opening:
– the crevice nozzle, to clean narrow and difficult to reach locations.
– the wet suction nozzle to vacuum up liquids.
NOTE: After you have vacuumed up liquids, immediately clean the dirt contai-
ner. Otherwise, bacteria or mould will build up inside! Ensure that the dust filter
bag is completely dry before using the appliance again.
3) To switch the appliance on, slide the on/off switch forwards. The charge
indicator lamp lights up green.
4) When you have finished using the appliance, slide the on/off switch to the
rear.
NOTE: Place the handheld vacuum cleaner in the wall bracket and start the
charging process once the vacuum power has become noticeably weaker and
the charge indicator lamp flashes green.
CLEANING AND MAINTENANCE
To achieve the best results, empty the dirt container and clean the dust filter
after every use.
CAUTION! MATERIAL DAMAGE!
• Do not use aggressive, chemical or abrasive cleaning agents. These could
damage the outer surfaces of the appliance.
1) To open the dirt container, press the release button and remove the dirt
container.
2) Remove the dust filter from the dirt container.
3) Empty the dirt container.
4) Pull the dust filter bag with its holder out of the dust filter.
5) Rinse the dust filter bag out in cold water and wait until it is completely dry
before reinserting it into the dust filter. Do not dry it with hot air.
6) Reinsert the dust filter into the dirt container. When doing so, ensure that
the dust filter is seated squarely and that the rubber lip seals the dirt container.
7) Replace the dirt container on the motor unit again:
– Push the plastic tab on the underside of the handheld vacuum cleaner into
the recess on the dirt container.
– Press the release button and push the dirt container onto the motor unit at
the same time.
– Let go of the release button so that the restraint engages in the recess.
The dirt container is now firmly seated on the motor unit.
8) Clean the housing and both nozzles with a lightly moistened cloth. For stub-