Velleman velLight LEDS11SRGB Manual Del Usuario página 7

3. Connect the included power adapter to the controller (see
[A3]).
4. Plug the adapter into the mains. Refer to illustration [A4] for a
general connection scheme.
7. Remote Control
Battery
Refer to illustration [B1] on page 3 of this manual.
The remote control uses 1 battery type 3 V lithium CR2025
(included). Remove the tag from the battery compartment before
use.
1. To (re)place a battery, press on the side of the battery cover
and pull to slide open.
2. Insert the battery with the correct polarity and close the battery
compartment by pushing back into the housing of the remote
control until it snaps into place.
Operation
1. Aim the remote control towards the IR LED of the controller to
control the output of the LED strip.
2. Switch on the LED strip with the ON button on the remote
control. To switch it off again, press the OFF button.
3. Refer to chapter 5. Overview for more information about
operating the remote control.
8. Technical Specifications
IP rating
coating
colour
wavelength
power consumption
viewing angle
LED spacing
V. 01 – 18/05/2015
LEDS11SRGB
IP61
silicone
red/green/blue
red
615-630 nm
23,8 W (red 8,8 W/green 7,5 W/blue 7,5 W)
120°
33 mm
7
green
520-530 nm
blue
465-470 nm
©Velleman nv