Saw Blade Mounting And Dismounting - Hitachi Koki C 10FSHC Instrucciones De Seguridad Y Manual De Instrucciones

SAW BLADE MOUNTING AND DISMOUNTING

WARNING:
* To prevent an accident or personal injury, always turn off the trigger
* If the 8 mm bolts are attached or detached using tools other than
1. Dismounting the blade (Fig. 44-a, Fig. 44-b, Fig. 44-c and Fig. 44-d)
(1) Unplug the power cord from the outlet.
(2) Raise the cutting head to the upright position and slide the cutting head completely
toward the rear of the unit and tighten the slide securing knob.
(3) Raise the lower guard to the up position.
(4) Remove the cover plate screw with a Phillips screwdriver.
(5) Place the blade end spanner over the 8 mm bolt.
(6) Locate the spindle lock on the motor.
(7) Press the spindle lock, holding it in fi rmly while turning the blade clockwise. The
spindle lock will then engage and lock the arbour. Continue to hold the spindle lock,
while turning the spanner clockwise to loosen the 8 mm bolt.
(8) Remove the 8 mm bolt, washer (B) and the blade. Do not remove the washer (A).
NOTE
: If the spindle lock cannot be easily pressed in to lock the spindle, turn
the 8 mm bolt with 13 mm wrench (standard accessory) while applying
pressure on the spindle lock.
The saw blade spindle is locked when the spindle lock is pressed inward.
NOTE
: Pay attention to the pieces removed, noting their position and direction
they face. Wipe the washer (B) clean from any sawdust before installing a
new blade.
switch and disconnect the power plug from the receptacle before
removing or installing a saw blade.
If cutting work is done in a state where the 8 mm bolt is not suffi ciently
tightened, the 8 mm bolt can get loose, the blade can come off , and
the lower guard can get damaged, resulting in injuries.
Also, check that the 8 mm bolts are properly tightened before
plugging the power plug into the receptacle.
the 13 mm wrench (standard accessory), excessive or improperly
tightening occurs, resulting in injury.
English
37