Armstrong BPA S2 Manual De Instalación página 26

security warnings
• It is necessary to read the installation manual completely
before installing the pressurizer pump and clarify any doubts
with your supplier prior to installation.
• Visually inspect the unit after it is unpacked. If you notice
bumps or damage to the cabinet and power cord DO NOT
install the unit.
• No work should be done with the pressurizing pump while it
is connected to electrical power.
• The pressurizer pump is designed to work only with clean,
solid-free, liquid or hot water according to the parameters
indicated in the technical specification table.
• The pressurizing pump should not be operated with
flammable liquids for any reason.
• The pump is designed to work inside. Its degree of
protection is ip42 which means that it is protected against
solids (tools and cables) greater than 1 mm and against
injected water spray at an angle less than 15 degrees of the
vertical.
• Do not expose the pressurizing pump to water vapor in the
environment and keep electrical parts out of contact with
water.
• The pump must not operate in temperatures below 0°c.
• Keep the pressurizer pump out of the reach of children. The
shell of the pump can reach high temperatures and cause
burns.
• Install the pressurizer pump with an independent
thermomagnetic switch.
26
www.armstrongfluidtechnology.com