Publicidad
Idiomas disponibles
Idiomas disponibles
Models: 2304 • 2305 • 2306
TOOL NEEDED:
AsseMBlY INsTRUCTIoNs
r &
Phillips head screwdriver
Find a large, clean area to assemble your appliance�
Remove all packing material before assembling�
Sharp edges. Wear gloves while assembling.
NOT INCLUDED:
lPG cylinder
0 lb (9 kg)
0 lb (9 kg)
size: 4 x 8 in (10 x 20 cm), 1 lb (453 g)
size: 4 x 8 in (10 x 20 cm), 1 lb (453 g)
ollar to
ollar to
Place the griddle body on a smooth flat surface� screw the
STEP 01
four (4) griddle feet into the bottom of the griddle�
NOT INCLUDED:
22" griddle base
BLACKSTONEPRODUCTS.COM/SUPPORT
TOOL NEEDED:
Adjustable wrench
CAUTIoN
TOOLS NEEDED:
NOT INCLUDED:
Phillips head screwdriver &
AA battery
Adjustable wrench
NOT INCLUDED:
lPG cylinder
size: 18 x 12 in (45 x 30 cm), 20 lb (9 kg)
size: 18 x 12 in (45 x 30 cm), 20 lb (9 kg)
lPG cylinder must include collar to
lPG cylinder must include collar to
protect lPG cylinder valve.
protect lPG cylinder valve.
NOT INCLUDED:
17" griddle base
CLEANING THE BURNER ASSEMBLY
TOOL NEEDED:
To reduce chance of "flash-back" the procedure below should be
5mm Allen wrench
followed at least once a month when spiders are most active or
when your appliance has not been used for a period of time�
VIDEO TUTORIAL
How to Clean Your Burner Tube
youtube.com/watch?v=xKQTCrFCzf8
ensure that the gas is turned oFF at control knobs and gas
STEP 01
supply� Remove the griddle top�
Carefully detach and
STEP 02
remove the burner�
Clean the inside of
STEP 03
TOOL NEEDED:
NOT INCLUDED:
the burner:
Phillips head screwdriver
AAA battery
• Run a narrow bottle brush
through each burner tube
several times� (do NoT use
wire brushes)
• Run a stiff wire bent into a small
hook through each burner tube
several times�
• Use compressed air to blow
through the burner tube and
out the burner ports� Check that
set the griddle on its feet� ensure that the ignition needles
STEP 02
air blows through each hole�
are set 3-7mm above the burner tubes�
(Wear eye protection)
ensure that the fuel nozzles are seated in the burner openings�
Brush entire
STEP 04
outer surface of burner to
remove grime�
NOT INCLUDED:
Clean any blocked ports
STEP 05
lPG cylinder
with stiff wire such as an open
size: 4 x 8 in (10 x 20 cm), 1 lb (453 g)
size: 4 x 8 in (10 x 20 cm), 1 lb (453 g)
paper clip�
Carefully replace
STEP 06
burners and reattach, with
attention to the location of the
ignition needle�
3-7mm
3-7mm
NOT INCLUDED:
22" griddle base
ASSEMBLY GUIDE
| OWNER'S MANUAL
TOOL NEEDED:
Adjustable wrench
ELECTRIC REQUIREMENTS:
120V 60Hz
NOT INCLUDED:
AA battery
Fuel nozzle
Fuel nozzle
NOT INCLUDED (OPTIONAL):
Two (2) d batteries
Burner opening
Burner opening
The gas rail fuel nozzle
must be reengaged within the
burner opening�
CU
Visi
for a
you
CUS
TOOL N
5mm A
NOT IN
AAA ba
05
Publicidad
