Publicidad
Idiomas disponibles
Idiomas disponibles
vance p roperly and will r esult inim-
proper cutting head f unction orcan
cause s erious injury. Donot u se other
materials
such aswire, string, rope,
etc. W ire c an break o ff d uring c utting
and become adangerous
missile that
can cause s erious injury.
1. Cut a length of80feet o f0.080" (2
mm) diameter
round C raftsman
brand l ine.
Spool
2. Insert one end ofline into center
cavity ofempty spool. Ensure line
will f eed into spool inthe direction
shown onthe spool (counterclock-
wise).
3. Continue
feeding line into spool,
leaving 4- 6inches (10 - 15cm)
unwound
from center ofspool.
INSTALLING
SPOOl
WITH lINE
1. Install replacement
spool.
2. Thread line through line guide ring.
Line through guide ring
ff
Replacement Spool
3.
Rest guide ring on spool and place
line through slot. Allow line to ex-
tend 4 - 6 inches (10 - 15 cm) from
center of spool.
4.
Ensure line remains in slot while
screwing cap on to the shaft. Only
tighten cap hand tightt
CARBURETOR
ADJUSTMENT
_WARNING:
The trimmer head
will be spinning
during most of this
procedure.
Wear your protective
equipment
and observe all safety pre-
cautions.
After making mixture adjust-
ments, recheck
idle speed.
Carburetor
adjustment
is critical and if
done improperly
can permanently
damage
the engine as well as the car-
buretor. If you require further assis-
tance or are unsure about performing
this procedure,
call our customer as-
sistance
help line at 1-800-235-5878.
Old fuel, a dirty air filter, a dirty fuel fil-
ter, or flooding
may give the impres-
sion of an improperly
adjusted
carbu-
retor. Check these conditions
before
adjusting
the carburetor.
The carburetor
has been carefully set
at the factory. Adjustments
may be
necessary
if you notice any of the fol-
lowing conditions:
• Engine will not idle. See IDLE SPEED
under adjusting
procedure.
• Engine dies or hesitates
instead of
accelerating.
See ACCELERATION
CHECK under adjusting
procedure.
• Loss of cutting power. See MIXTURE
ADJUSTMENT under adjusting
procedure.
There are two adjustment
screws on
the carburetor,
a mixture screw and an
idle speed screw.
_dle
Speed
Screw
Mixture
Screw/_,r_
,
.
(with Li_t-ery
Q_,.
A,r Filter
Cap) _
Cover
ADJUSTING
PROCEDURE
CAUTION:
Do not force plastic limiter
caps on screws beyond the built-in
stops or damage
will occur.
Be sure
trimmer line is extended
to the maxi-
mum length allowed by the line limiter
blade.
Initial Settings:
1. Turn mixture screw counterclock-
wise until it stops.
2.
Turn the idle speed screw clockwise
until it stops. Now turn counterclock-
wise 4 1/2 turns.
3.
Start engine, cut grass for 3 min-
utes, then proceed to adjust screws
according to the instructions below.
If engine performance at initial set-
tings is acceptable, no further ad-
justments are necessary.
If engine
does not start, refer to TROUBLE-
SHOOTING TABLE. If still unable to
remedy situation, call
1-800-235-5878.
lO
Publicidad
