Cleaning The Filter Cartridge - Koenic KDW 60111 A2 FS Manual De Instrucciones

English
Legal note:
* EN 50242: This program is the test cycle.
The information for comparability test in
accordance with EN 50242, is as following:
- Capacity: 14 setting
- Upper basket: top wheels on rail.
- Rinse aid setting: 6
- The power consumption of the:
mode is 0.45 W
mode is 0.49 W
Left-on mode duration: Power will be cut
off automatically after program finished for 30
minutes.
Cleaning and care
Warning
• When cleaning, never use solvents or
abrasive materials, hard brushes, metallic
or sharp objects. Solvents are harmful to
human health and can attack plastic parts,
while abrasive cleaning mechanisms and
tools may scratch the surface(s).
• Clean the exterior surfaces of the product
with a slightly damp cloth and dry them
well. Make sure that no water enters the
product interior (e.g. at the switches).
• Clean the edge around the door using a
soft, warm and damp cloth only. To avoid
penetration of water into the door lock
and electrical components, do not use a
spray cleaner of any kind.

Cleaning the filter cartridge

The filter prevents larger remnants of food or
other objects from getting inside the pump.
Inspect the filters for blocking every time after
the dishwasher has been and clean it on a
regular basis.
28
IM_KDW 60111 A2 FS_170802_V08_HR.indb 28
The filter system consists of a coarse
Fig.
13
filter, a flat (Main filter) and a micro
filter (fine filter).
• Main filter A: Food and soil particles
trapped by this filter are pulverized
by a special jet on the spray arm and
washed down to drain.
off- • Fine filter B: This filter holds soil
and food residue in the sump area
left-on and prevents it from being spread
over the dishes during wash cycle.
• Coarse filter C: Larger items, such
as pieces of bones or glass that could
block the drain are trapped in the
coarse filter. To remove the items
caught by the filter, gently squeeze
the tap on the top of this filter and
lift it up.
Disassemble and clean the filter
according to the following steps:
• Turn the filter cap (filter C)
counterclockwise and take out the
whole filter cartridge.
• Take out filters B and C.
• Take out filter C.
• Wash filters under running water.
• Reassembling is done in reverse
order. Make sure the filter cartridge is
installed correctly.
Warning
Do not use the dishwasher without the filter
system being properly installed.
Cleaning the spray arms
The spray arms can be easily removed
Fig.
14
for periodic cleaning of the nozzles.
This prevents possible clogging.
• Grasp the middle of the spray arm,
pull it upwards to remove it.
• Wash the arms under a jet of running
water .
• Return them carefully to their seat
and make sure that the spray arms
are installed correctly and can turn
freely.
2/8/17 12:02 pm