Allowed and disallowed positioning of
Axkid MOVEKID car seat
Axkid MOVEKID car seat can only be installed rear-facing. It will fit in most, but not all seating positions. Check your vehicle instruction
manual to find suitable seating positions and check the vehicle list on www.axkid.com
Front passenger seat (no active airbag)
Front passenger seat (active airbag)
Rear passenger seat with 3-point seat belt
Seat with 2-point seat belt
Side and rear facing seats
IMPORTANT: If you wish to install your Axkid MOVEKID car seat in a location where a frontal airbag is fitted, the airbag must be discon-
nected according to your vehicle manufacturer instruction. Note that some vehicles require an authorized service centre to disconnect
the airbag.
* The General Regulation of Traffic in Spain, in its article 117, establishes the prohibition of driving with children of stature equal to or less
than 135 centimetres located in the front seats of the vehicle, without exceptions.
Lower Tether Anchorages
Important info
Lower Tether Anchorages (LTA) are used to enhance the protection of children in cars by providing a firm and stable installation for
extended rear-facing belt attached car seats. This increases the safety for your child in all types of collisions, including roll-over accidents
and rear-end impacts.
Lower tethers are a well-established method that has been extensively used in the Nordic countries for over 40 years. In 2020 a new
international standard for LTA, ISO13216-4:2020, was released. This standard describes the requirements for lower tethers for car seats
but also for vehicle manufactures and their anchor points. The purpose is to improve the compatibility and ensuring a safe and easy way
of installation for the future.
Axkid MOVEKID indcludes two lower tethers for installation in cars with or without lower tether anchorages. The included lower tethers
complies with ISO13216-4:2020 to ensure a perfect fit, and easy installation, in vehicles with pre-installed lower tether anchorages that
also complies to this standard. If your vehicle has anchorage points that do not comply with the standard, Axkid MOVEKID lower tethers
are still likely, but not guaranteed, to fit.
Pre-installed lower tether anchorages in vehicles are often found on the seat rails attached to the floor, but other positions are also used.
Check your vehicle' s instruction manual for more information on usable anchor points.
Axkid MOVEKID comes with everything you need to install the car seat in your vehicle. However, lower tether anchorages and extra
lower tether anchorage straps can be purchased seperately and will make installation quicker and easier in multiple cars. Some vehicle
manufactures also offers the possibility of retrofitting lower tether anchorages. Contact your vehicle manufacturer or dealer for more
information. Axkid retrofit lower tether anchorages and extra lower tethers can be purchased separately.
Note: Never use Axkid MOVEKID without the lower tethers. They are an important safety feature and must always be used when install-
ing your car seat.
YES/NO*
NO
YES
NO
NO
16
16