Descargar Imprimir esta página

Craftsman 917.293484 Manual Del Usuario página 18

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGINE
Maintenance,
repair, or replacement
of
the emission control devices and sys-
tems, which are being done at the
customers expense,
may be performed
by any non-road engine repair establish-
ment or individual.
Warranty repairs must
be performed
by an authorized
engine
manufacturer's
service outlet.
TO ADJUST
THRO'rFLE
CONTROL
CABLE
1. The throttle control has been preset at
the factory and adjustment should not
be necessary,
if adjustment is
necessary,
proceed as follows:
2. With engine not running, move remote
throttle control lever to "FAST
position.
3.
If throttle lever on engine touches high
speed stop, no further
adjustment is
necessary.
If throttle lever does not
touch high speed stop, continue with
adjustment
procedure.
4.
Loosen cable clamp screw.
5.
Move throttle lever up until it touches
high speed stop, and hold in this
position.
6. Tighten
cable clamp screw securely.
Clamp Screw
\
Casing
and Wire,,.,,
"X_
"
m
Governor
Control Lever _
TO ADJUST
CARBURETOR
The carburetor has been preset at the
factory and adjustment should not be
necessary.
However, engine perfor-
mance can be affected by differences in
fuel, temperature,
altitude or load. If the
carburetor does need adjustment,
contact
your nearest authorized
service center/
department
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed.
Overspeeding
the
engine above the factory high speed
setting can be dangerous.
If you think the
engine-governed
high speed needs
adjusting, contact your nearest autho-
rized service center/department,
which
has the proper
equipment
and experi-
ence to make any necessary
adjust-
ments.
18

Publicidad

loading