Publicidad
Idiomas disponibles
Idiomas disponibles
▶ Remove the battery/batteries.
▶ Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage of cordless power tools and batteries
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9
Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the section
headed Status indicators of the Liion battery. 6
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, please contact Hilti Service.
Trouble or fault
Control switch cannot be
pressed or is stuck.
Product does not work.
The battery runs down more
quickly than usual.
The product or battery gets
very hot.
The battery does not engage
with an audible click.
LEDs of the battery show
nothing
10
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
*2369076*
Possible cause
The forward/reverse switch is in
the middle position.
Battery not fully inserted.
Very low ambient temperature.
Electrical fault.
Retaining lug on the battery dirty.
Battery faulty.
2369076
Action to be taken
▶ Set the forward/reverse switch
to the desired direction of
rotation. 9
▶ Push the battery in until it
engages with an audible click.
▶ Allow the battery to warm up
slowly to room temperature.
▶ Switch the product off immedi-
ately, remove the battery, keep
it under observation, allow it
to cool down and contact Hilti
Service.
▶ Clean the retaining lug and
engage the battery in the
working position.
▶ Contact Hilti Service.
English
11
Publicidad
