GE PXRQ15RBL Manual Del Propietario Y Instalación página 16

FAUCET ASSEMBLY (cont.)
OPTIONAL ONE-PERSON
FAUCET TUBING INSTALLATION
1.
tube (blue banded) in one hand with the drain
tubes the same length and the outlet tube offset
approximately 6 inches.
2. Wrap a rubber band around all 3 tubes.
3. Insert a typical No. 2 pencil through the rubber
band location.
4. Rotate the pencil down until it is in line with
the tubing and push up through the mounting
hole. Release the grip on the pencil and the
tubes will remain in position for easier faucet
connection.
Installation Instructions
16
INSTALL THE BATTERY
1. Remove the lens cover from the faucet base.
Grip it from both sides and pull forward.
2. Install one CR2032 3V battery with the
battery tray completely back into the base.
Faucet base
Lens cover
3. The amber light will illuminate five times. If
you want to reinitiate the start-up sequence,
remove the battery for 90 seconds so the
electronics can fully reset; then put the battery
back in.
4. Normally, the light is off. After 6 months of use,
the amber LED light will flash every 30 seconds
indicating it is time to replace the filter canister.
NOTE: The amber LED light may stop blinking if
it is allowed to blink for an extended period of
time. To ensure proper operation, the battery
should be replaced with every filter change.
FOR FILTER CHANGE: Replace the battery
when changing the filter. Remove the used
battery and wait 90 seconds before installing
the new battery to ensure the proper
electronics are reset for the next
6 months.