Whittier Wood Furniture Mission Serie Instrucciones Para Armar página 3

Tools Required: Phillips Screwdriver, 9/16" or Adjustable Wrench, Mallet or Padded Hammer, Wood Glue
1. Place the Top Assembly (Ab) upside-down on a clean, protected surface. Gently tap the Slats (Cb)
into place with a mallet or padded hammer. DO NOT GLUE THE SLATS. See Figure 1.
2. Position the Shelf Assembly (Db) so that the slats line up with the holes on the right and left sides.
Lower the Shelf Assembly on to the Slats and gently tap into place with a mallet or padded hammer.
See Figure 2.
314Wb, 316Wb, 318Wb, 319Wb
Mission Table Collection
Assembly Instructions
Apply finish to this unit before you begin this assembly.
Before doing so, read the enclosed finishing hints.
Cb
Fig. 1
Fig. 2
IMPORTANT:
314Wb shown in the following illustrations.
Ab
Db
DO NOT GLUE
THE SLATS.
Page 3 – 314Wb/316Wb/318Wb/319Wb – 04/10