GE SmartWater GXWH35F Instrucciones De Instalación página 2

CARTRIDGE SPECIFICATIONS
Performance Data
This system has been tested according to NSF/ANS] 42
tor the reduction of the substances listed below. The
concentration of tile indicated substances in water
entering tile svstem was reduced to a concentration
less than or equal to tile permissible limit tor water
leaving the system, as specified in NSF/ANS] 42.
FXHTCCartridge
Influent Challenge Reduction Average
Substance Concentration Requirements Reduction
Standard42
Chlorine 2.0 mg/L+10% > 50% 93.1%
TestConditions OperatinqRequireroents
Flow Rate:3 gpm(11.4 Lpm) Pressure:30 125 PSi(2.1 6.9bar)
pH: 7.5_+1 Turbidity:5 NTUMax.
Inlet Pressure: 6 0 PSi(4.1 bar) Temperature: 4 0°_100°F (4.4°C_7.7°C)
Temperature: 6 8°F_+5°F(19.8°C_+ 2.5°C) Capacity:5,000gallons (18,927L) o r 3 roonths
Testingwasperfom?edunderstandardlaboratoryconditions,actnalperformancemay vary
Filter Cartridge Replacement
Q
_)u should change ._our filter _hen tile _ater flo_ is noticeably reduced or at least exeP,., months.
F_] Turn off',_ater to filtel; _ater must be shut off from [] Slo_d} turn on ",_ater to tile filter b? usin,, tile
an upstream valxe, upstream shut-off
valve.
Press tile red pressttre release btfftoll it) ren/(we
[_ Press tile red pressure release btttton to release [_]
trapped
;tit:
pressttre.
_] [)nscrew tile filter canister and discard used filter:
_tsll the filter canister with mild soap and _ater.
Do not use hmMl cleaners or hot _ater.
V_ _Mter installation, flush tile carhidge tbr
10 minutes, *_ait one hour, then flush again
fiw 10 minutes befiwe using tile _atet:
[_] hlspect the filter canister O-_ing. Make sm'e it is
light]} lubricated with clean tbod grade silicone
grease (silictme grease is available through GE
Parts and SeiMce: 1.800.626.2002, I:)art number
_S60XI0005). Be sure the o-ring is seated in the
groove. It is recommended that you replace tile
O-ring if it is damaged.
[_ Place a new filter cartridge int() tile canister,
making sure it is centered and completel_ seated
on tile bottom seal.
@Reinstall the filter canister to tile mlit. Use tile
canister wrench to tighten the canistel: DO NOT
OVERTI(;HTEN.
Remotetimer
/
Red pressure _-1__
release button
I p,91_ Head
_2trteri_ .
-,qt_ Orangseal
/_ [)U_ FHterca°islet
I _ Turn
I I
counterclockwise
i[i_lilkw_s\; _ to'' ' tigilteo
canister
Turncanisterwrench
clockwiseto remove
Canister
Installation Overview
NOTE:Be sure to allow a minimum space
of 1½"-2" under the filter for removing
the sump to change the cartridge.
STEP-BY-STEP INSTALLATION INSTRUCTIONS
Mounting
bracket
Fitting
Recommended
shut-off v alve
HexIlUt
Ferrule / _
Typical installation