Publicidad
Idiomas disponibles
Idiomas disponibles
Remote control
In addition to the panel controls, a remote control is included which provides additional functions to allow greater control
over the media player.
• Install the batteries in the remote control following the correct polarity as indicated inside the compartment. (Requires
two AAA batteries).
• In order for the remote to operate properly, ensure that it is pointed toward the front of the speaker.
1
2
3
4
5
6
7
8
Control
Press this button briefly to turn the speaker on/standby
1. Power button:
Press this button briefly to toggle through the different audio sources available:
2. Mode button:
, USB, microSD™, Aux, and FM.
Bluetooth
®
Stops audio playing. It only works on USB and microSD™ mode. After pressing stop
3. Stop button:
and turn on the speaker again. Audio playback begins in the first song of the playlist.
4.Volume + button:
Increases the volume level of the speaker.
5. Previous button:
In Bluetooth
, USB/microSD™, press this button briefly to play the previous track.
®
Press and hold this button to fast backward tracks on your playlist. In FM mode
press it briefly to go to the previous radio station.
Decreases the volume level of the speaker.
6. Volume – button:
7. Repeat button:
It is used in USB and microSD™ modes to repeat a single track or repeat all tracks.
In USB and microSD™ modes, press any key from 0 to 9 on the remote to choose
8. Numbered keypad:
directly the tracks you want to play. In FM mode it allows the manual input of
radio stations.
MODE
9
STOP
MUTE
VOL+
10
11
CH-
CH+
VOL-
12
REP
EQ
1
2
3
4
5
6
7
8
9
0
Description
Cancels the audio coming from the speaker. Press it again to unmute the speaker in all modes.
9. Mute button:
Press to play and pause media during Bluetooth
10.Play/pause/TWS button:
hold this button until you hear a beep, then it's ready for TWS pairing.
In Bluetooth
, USB, and microSD™ mode, press this button briefly to play the next track.
®
11.Next button
Press and hold this button to fast forward tracks on your playlist. In FM mode, press it
briefly to go to the next radio station.
Use it to scroll through the different sound effects (normal, rock, pop, jazz, classical, and country).
12. EQ button:
IV. Initial setup
Note: For your safety, read this manual and follow all safety instructions before using the product.
Charging the battery
1. Plug the AC cable to a wall outlet.
2. When the unit is not in use or switched off, it will automatically recharge the internal battery as long as it
remains connected to utility power.
3. The charging LED indicator lights up in red when the unit is charging. When the battery is fully charged,
the charging LED indicator turns off.
Powering on the unit
1. Press the power switch to the on position.
2. Connect audio input devices first. Make sure that all input sources such as microphones or digital media
players are turned off and volume settings are set to their lowest settings (zero).
3. Connect one end of the AC cable to the loudspeaker and the other end to the wall outlet.
4. Press the power switch to turn on the speaker.
5. Turn the volume clockwise slowly until the sound reaches the desired level. If there is no sound, check to
make sure the source device is providing audio output.
Using the wireless microphone
1. Insert the two AA batteries into the handheld microphone by carefully unscrewing the base and aligning the
"+" and "-" terminals of the batteries with the corresponding contacts inside the compartment.
2. Turn on the microphone. The speaker will detect the device automatically.
3. When not in use, switch the wireless microphone off to save battery power.
Using a wired microphone
1. Connect the wired microphone to the 6.35mm microphone input jack. Please do not plug the microphone
when the unit is charging.
2. While connected, you can control the microphone volume and echo effect by rotating the corresponding
knobs on the top panel of the speaker.
V. Operating modes
1. Auxiliary playback
a. Use the supplied audio cable to connect the speaker to external audio devices through the Auxiliary input
located on the top panel.
b. If the speaker is not set to the AUX IN mode, press the Mode button until the corresponding input mode is
found.
c. When the AUX mode is displayed on the screen, you can start streaming audio directly from compatible
multimedia sources.
d. Please take into account that the previous and next track buttons don't work on this mode.
, microSD™, or USB playback. Press and
®
Publicidad
