Descargar Imprimir esta página

Craftsman 917.28603 Manual Del Operador página 28

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE:
Fuel stabilizer
is an acceptable
al-
ternative
in minimizing
the formation
of fuel
gum deposits
during storage.
Add stabilizer
to gasoline
in fuel tank or storage
container.
Always
follow the mix ratio found on stabilizer
container.
Run engine
at least
10 minutes
after adding stabilizer
to allow the stabilizer
to
reach the carburetor.
Do not empty
the gas
tank and carburetor
if using
fuel stabilizer.
ENGINE
OIL
Drain
oil (with
engine
warm)
and
replace
with clean engine
oil. (See "ENGINE"
in the
Maintenance
section
of this manual).
CYLINDER(S)
1.
Remove
spark
plug(s).
2.
Pour one ounce of oil through
spark plug
hole(s)
into cylinder(s).
3.
Turn ignition
key to "START"
position
for
a few seconds
to distribute
oil.
4.
Replace
with new spark
plug(s).
OTHER
, Do not store gasoline from one season to
another.
, Replace your gasoline can ifyour can starts
to rust.
Rust and/or dirt in your gasoline
will cause problems.
, If possible, store your tractor indoors and
cover it to give protection from dust and dirt.
* Cover your tractor with a suitable protec-
tive cover that does not retain moisture.
Do not use plastic. Plastic cannot breathe
which allows condensation
to form and will
cause your tractor to rust.
iMPORTANT:
Never
cover
tractor
while
engine
and exhaust areas are still warm.
TROUBLESHOOTING
CHART:
See appropriate
section
in manual
unless
directed
to Sears service
center
PROBLEM
Will
not start
1
2
CAUSE
Out of fuel.
Engine not "CHOKED" properly.
3
Engine flooded.
4
Bad spark plug.
5
Dirty air filter.
6
Dirty fuel filter.
7
Water in fuel.
8
9
10
1
2
3
4
5
6
7
Loose or damaged wiring.
Carburetor out of adjustment.
Engine valves out of adjustment.
Dirty air filter.
Bad spark plug.
Weak or dead battery.
Dirty fuel filter.
Stale or dirty fuel.
Loose or damaged wiring.
Carburetor out of adjustment.
1
2
4
5
6
7
8
9
10
1
2
3
4
5
6
7
Hard to start
CORRECTION
Fill fuel tank.
See "TO START ENGINE"
in
Operation section.
Wait several minutes before
attempting to start.
Replace spark plug.
Clean/replace air filter.
Replace
fuel filter.
Empty fuel tank and carburetor,
refill tank with fresh gasoline and
replace
fuel filter.
Check all wiring.
See "To Adjust Carburetor" in
Service and Adjustments section.
Contact a Sears or other qualified
service center.
Clean/replace
air filter.
Replace spark plug.
Recharge
or replace battery.
Replace
fuel filter.
Empty
fuel tank and refill tank with
fresh, clean gasoline.
Check all wiring.
See "To
Adjust
Carburetor" in
Service and
Adjustments
section.
28

Publicidad

loading