Descargar Imprimir esta página

Panasonic CT-9R11 Instrucciones De Operación página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

ACTION
—- VOLUME + VCHANNELA
ACTION Button (On TV)
Press the ACTION button (on television} to access
and exit all Video and Set-Up Menus.
Press the CH
UP and CH DOWN
buttons to select the options.
Press the VOL
UP and VOL
DOWN
buttons to
adjust the options.
Video Menus
COLOR
TINT
BRIGHTNESS
L\AXE
Power Sources
The CT-9R20 modet television operates on 120 Volt,
60Hz AC and 12 Volt negative-ground car battery
systems through the cigarette lighter socket.
Two
power cords (AC Power Cord and Car Battery Cord)
are supplied.
House Current Operation
insert the AC power cord (supplied) into the socket
on the rear of the television and connect the plug to
a wall outlet (120 Voit, GOHz). The plug is polarized
for safety.
If you are unable to insert the plug fully
into the outlet, try reversing the plug.
If the plug
should still fail to fit, contact your electrician.
Do not
defeat the safety purpose of the polarized plug.
CAUTION:
TO PREVENT ELECTRIC SHOCK DO
NOT
USE
THIS
(POLARIZED)
PLUG
WITH
A
RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT
BLADE EXPOSURE.
Car Battery Operation
Prior to Use:
Before connecting the car battery cord (supplied),
check the polarity of your car battery. The car cord
supplied
is designed
for use
with
a negative
grounded battery.
If your car has a positive ground,
consult your Panasonic dealer.
If you have any
questions
concerning
the car polarity or battery
voltage, consult your car dealer.
BACK OF TV
To Cigarette Lighter
Socket (12V/DC}
Car Battery Cord
Ns
AC Wall Outlet
120V/AC
AC Power Cord
Video Menus (cont.)
PICTURE
SHARPNESS
PICTURE NORM
Set-Up Menus
AUTO PROGRAM
MANUAL PROGRAM
ANTENNA
LANGUAGE
Connection and Use:
Remove the cigarette lighter from your car and insert
the car battery cord plug in its place.
Insert the car
cord into the socket on the rear of the television.
To
turn television ON, press the POWER button.
Notes
While the car is moving, it may be difficult to
obtain good reception due to signal variations.
It is recommended
to operate with the engine
idling under the following conditions:
a.
Very
low
outside
temperatures
likely
to
cause difficult engine starts.
b.
Viewing the television for more than just a
few hours.
(For personai safety when in a
vehicle with engine idling, always: keep a
window
slightly
open
to
prevent
being
overcome from possible engine fume leaks).
Do not operate the set when starting the engine
to avoid overloading the engine.
When finished viewing, press the POWER button
to turn OFF
and disconnect
power
cord from
cigarette lighter.
Failure to do so may discharge
your car battery.
Car Cord Plug
Terminal Tip
@). No Line on Cord)
(©, White
Line
Fuse
Cap
on Cord)
Fuse Replacement
if the car cord does not seem
to function normally,
check if the fuse in the plug is blown.
If the fuse is
blown, replace it with the spare fuse supplied.
Procedure
1.
Turn the television OFF and unplug car cord from
cigarette lighter socket.
Loosen and remove the cap.
Pull out the fuse.
Install the spare fuse supplied.
Replace the cap.
Plug the car cord into the cigarette lighter socket
and turn the television ON.
Notes
When the fuse is blown, replace it with the same
type, 7A-125V.
Never use an ordinary piece of
wire,
Always keep the cigarette lighter socket of the car
clean.
If the socket is dirty with cigarette ash, the
resulting bad contact may overheat the car cord
piug.
PRON

Publicidad

loading

Este manual también es adecuado para:

Ct-9r20