Publicidad
Idiomas disponibles
Idiomas disponibles
q Connecting power supply wire and communication wires
Screw
(Upper side)
Screw
(Lower side)
Electrical control box cover
Cable clamp (Accessory)
Communication wire
Clamp all cables
Clamp the communication wire
Clamp the communication wire
Communication wire
EN-21
01_IM_1143017001-1_EN.indd 11
01_IM_1143017001-1_EN.indd 11
Screw
(Upper side)
Screw
(Lower side)
Ground screw
Cable clamp
Lock nut
Conduit pipe
Power supply wire
L1 L2
Power supply terminal block
A B
Communication wire terminal block
Ground screw
Cable clamp
Power supply wire
Lock nut
Conduit pipe
Clamp all cables
Cable clamp (Accessory)
L1 L2
A B
Power supply terminal block
Communication wire terminal block
11
0.4"
(10)
0.4"
L1 L2
0.2"
(10)
(5)
2.0"
1.6"
1.4"
(50)
(40)
(35)
Ground wire
Power supply wire
Communication wiring
Terminal block for
remote controller
wiring of indoor unit
A
A
Flow Selector unit
B
B
terminal on PCB
Communication wires
(locally procured)
„ In the case of connecting two ports
The communication wire should be connected only to the port with the smaller number.
(In the figure below, Port No.1 and Port No.3)
Set the DN code according to the Installation Manual of the outdoor unit.
Outdoor unit
Flow Selector unit Multi-port type
Piping
1
2
3
Port No.
Indoor unit
Communication wire
(Unit: in (mm))
See the figure on the left
for connecting wires to
the terminal.
Communication wire
Communication wires
4
EN-22
24/11/2566 BE 15:06
24/11/2566 BE 15:06
Publicidad
