Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
* = The instructions are not given in this operator's
manual.
Maintenance
Lubricate all grease nipples.
Grease nipple on page
Refer to
24 .
Do a check of the parking
To examine
brake. Refer to
and adjust the parking brake on
page 18 .
Do a check of the safety sys-
Safety devices on
tem. Refer to
the product on page 9 .
Make sure that there are no
fuel or oil leaks from the prod-
uct.
Make sure that there are no
damages on the product.
Make sure that there are no
loose parts.
Do a check for damages on the
cutting deck.
Do a check of the tire pressure.
Refer to
Tire pressure on page
20 .
Start the engine and blades
and listen for unusual sounds.
Clean the inner surface of the
cutting deck. Refer to
the product on page 18 .
Clean around the engine.
Clean around the belts and the
belt pulleys.
Do a check of the battery con-
nectons.
16
Maintenance
Before you do any
Daily mainte-
nance
Before
use
X
*
*
*
*
X
*
To clean
X = The instructions are given in this operator's
manual.
O = Refer to the engine manual for instructions.
Maintenance schedule for the operator
Maintenance interval in hours
After
25
50
100
use
O
X
X
*
*
*
*
*
250
300
400
500
X
2320 - 001 - 29.11.2023
Each
season
*