BOMANN DBS 6034 CB Manual De Instrucciones página 40

Ironing Without Steam
NOTE:
Sort out the garments according to their ironing temper-
atures.
1. Place the iron on the rest.
2. Only connect the appliance to a properly installed safety
socket.
3. Adjust the temperature on the temperature control. If you
have sensitive items to iron, please begin with the lowest
temperature.
NOTE:
The control lamp on the iron indicates the heating
process. As soon as this goes out, the operating tem-
perature is reached. You can now begin ironing.
Steam Ironing
WARNING:
The iron expels a large quantity of hot steam. Danger of
burns!
CAUTION:
When using the steam iron please ensure that the water
tank is always filled to the required level.
CAUTION: Initial use:
Please proceed as follows:
1. Remove the water tank.
2. Open the lid of the water tank.
3. Fill the water tank with distilled water. Fill the water
tank to the maximal marking only. Do not overfill!
4. Close the lid of the water tank.
5. Push the tank back into the base. It must audibly snap.
6. Connect the base station to a socket with earthing
contact.
7. Set the required temperature in the range
. The control lamp on the iron lights up.
8. Wait until the sole plate has heated up. If the tempera-
ture has been reached, the control lamp goes out.
9. Now press the steam jet button for at least 15 sec-
onds or until the steam comes out of the sole plate.
Alternatively, you may set the lock onto the
generate continuous steam. This time is needed for the
steam to reach the iron. A slightly louder noise of the
pump is normal with this.
40
DBS6034CB_IM
CAUTION:
A high temperature is needed to iron with steam. Set the
temperature control at least to the
wise, the pump shuts off and steam ironing is no longer
possible.
Vertical Steam Function
This can be used to produce a jet of steam in a vertical
direction. This function can be used to remove creases from
hanging clothes or from curtains.
WARNING:
Never point the steam jet at other people. Danger of
burns!
Hang the washing on a hanger. Guide the iron closely over
the material as specified by the material.
How Can I Replenish the Water During Operation?
Refill with water before the tank is completely empty. A loud
noise of the pump during operation indicates that the water
level is too low.
1. Place the iron on the rest.
2. Set the temperature control to MIN.
3. Remove the mains plug from the socket.
4. Remove the water tank.
5. Open the lid of the water tank.
6. Fill the water tank only with distilled water. Fill the wa-
ter tank to the maximal marking only. Do not overfill!
7. Close the lid of the water tank.
8. Push the tank back into the base. It must audibly snap.
9. You can now continue ironing.
1. Always set the temperature control to MIN after use.
Remove the mains plug from the socket.
to
2. Allow the appliance to cool. Secure the appliance via the
transport lock before carrying or removing it.
Stowing the Cable
Stow the cable back into the cable compartment.
icon to
symbol. Other-
End of Operation
27.09.19