Publicidad
Idiomas disponibles
Idiomas disponibles
• Dismount the lower door hinge incl. foot and the door support assembly by loosening
the screws. Turn off the separate foot.
• Attach the lower door hinge incl. foot and the door support assembly at the respective
op-posite device side. Turn in the separate foot accordingly.
• Replace the device upright again.
Rotate the appliance door about 180°. Put the door on the lower door hinge pin and fix
it to its property position.
• Attach the upper door hinge on the opposite device side. Put the covers, which you
have removed at the beginning, accordingly on.
• Make sure that the door is aligned vertically as well as horizontally, so that a smooth opening and closing of the door is guaranteed.
Before initial use
CAUTION:
After transport, the appliance should be left standing upright for about 2 hours before connecting to the power supply. Nonobservance could lead to mal-
function of the cooling system and causes a breakdown of the appliance.
Clean the interior of the appliance including all accessory parts located inside. Consider the instructions which we provide in the chapter "Cleaning".
Starting the appliance
• Connect the appliance to the power supply;
• press the on/off button and use the temperature selector buttons. Read also the following section "Control panel".
Control panel
The temperature zones can be controlled and adjusted independently. The operating area A controls the upper and B the lower temperature zone.
Use the temperature selector buttons 1 and 2 to set the internal temperature in each zone:
• The temperature is getting warmer with the button [+] and colder with the button [-]. The set time will be changed in 1°C increments.
• Upper temperature zone (A) is adjustable between:
• Lower temperature zone (B) is adjustable between:
• The temperature value is adjustable max. 33°C below the ambient temperature. The optimal room temperature is about 20°C.
If you set the temperature, it takes some time until the desired temperature has been reached. Note that this is dependent on the ambient temperature and
setting.
With the button 3 you switch on or off the interior light in the zones.
Display indicators (4):
• The internal temperature will be selected by the display. First the default setting 7°C and 10°C is displayed. While the temperature dialing the temperature
value is flashing.
• A few seconds after the last button is pressed the temperature indication is automatically switched to the actual temperature value that exists currently in
the zone.
• With initial button press the display shows first the last set temperature value flashing.
Startup / Operation
5°C - 18°C
10°C - 18°C
47
Publicidad
