Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
To prevent the inside of the pipe from
narrowing when bending it, etc., pour
sand inside, block both ends and then
gently bend it.
5. Removing putty from window
frames (Fig.9)
Use nozzle (glass protector) to soften the
putty with heat, and then remove the
putty with the scraper supplied.
Note that glass may crack if heat is
continually applied to it.
Nozzle (Glass protector)
Scraper
6. Defrosting water pipes (Fig.10)
Use nozzle (curved surface) to heat the
frozen area from the edge to the center.
Do not mistake water pipes for glass
pipes.
Take care to avoid damaging frozen resin
areas on water pipes.
Nozzle
(Curved surface)
Fig. 10
Nozzle
(Curved surface)
Fig. 8
Fig. 9
[Effectively Using the Quick Cooling Button]
Press the quick cooling button and press
the switch to blow warm air at
approximately 50 degrees Celsius for
each of the switch's wind volumes.
This is used to quickly cool material that
is heat-warping and to cool the nozzle
when it reaches high temperatures after
using the Heat Gun.
English
11
Publicidad
Tabla de contenido
