CARE & CLEANING
Switch off the power supply
before cleaning
CS-E18DKDW, CS-E18DKEW
AIR FILTER
Vacuum, wash and dry.
Remove
SUPERSONIC AIR
PURIFYING DEVICE
Vacuum the super
alleru-buster filter.
Vacuum, wash and
dry the frame.
Hints
Clean the filter regularly as dirty filters will cause unpurified air, low cooling or heating capacity, unpleasant smells and higher
●
energy consumption.
The unit will become dirty and the performance of the unit will decrease after used for several seasons. Please consult an
●
authorized dealer to perform seasonal inspections in addition to regular cleaning.
This air conditioner is equipped with a built-in surge protective device. However, in order to further protect your air conditioner
●
from being damaged by abnormally strong lightning activity, you may want to disconnect it from the power supply. Do not touch
the air conditioner during lightning, it may cause electric shock.
FRONT PANEL
Raise and pull to remove.
Wash and dry.
Remove
Remove
INDOOR
UNIT
Wipe gently.
IONIZER
Clean with cotton
bud.
■ Cleaning Instructions
• Do not use benzene, thinner or
scouring powder.
• Use only neutral household
detergent ( pH7).
• Do not use water with temperature
higher than 40°C.
INDOOR UNIT
• Wipe the unit gently with a soft, dry
cloth.
AIR FILTER
• It is recommended to clean the air
filters once every 2 weeks.
• Purchase the replacement filter if it
is damaged.
Part no.: CWD001137 (Left)
CWD001138 (Right)
SUPER ALLERU-BUSTER
• It is recommended to clean the filter
every 6 months.
• Replace the filter every 3 years or
purchase the replacement filter if it
is damaged.
Part no.: CZ-SA13P
IONIZER
• It is recommended to clean the
ionizer every 6 months.
■ Preparation for extended
Non-operation
• Operate the unit for 2~3 hours using
heating operation to dry the internal
parts.
• Turn off the power supply.
• Remove the remote control batteries.
■ Pre-season Inspection
• This inspection is recommended
before operating the air conditioner
at every season.
• Check if the remote control batteries
needed to be replaced.
• Ensure there is no obstruction at all
air intake and outlet vents.
• After the start of operation for 15
minutes, it is normal if the
temperature differences between
air intake and outlet vents at indoor
unit is:-
Operation
Temperature
Cooling
8°C
Heating
14°C
13