Publicidad
Idiomas disponibles
Idiomas disponibles
Tip of }ine does
Line crowded
into
the cutting.
Riqht
'_/'roncl
• The line will easily remove grass
and weeds from around walls,
fences, trees and flower beds, but it
also can cut the tender bark of trees
or shrubs and scar fences. To help
avoid damage
especially
to delicate
vegetation
or trees with tender bark,
shorten line to 4 - 5 inches (10 - 13
cm) and use at less than full throttle.
• For trimming or scalping,
use less
than full throttle to increase
line life
and decrease
head wear, especially:
• During light duty cutting.
• Near objects around which the line
can wrap such as small posts,
trees or fence wire.
• For mowing or sweeping,
use full
throttle for a good clean job.
TRIMMING
- Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low only the tip of the line to make
contact.
Do not force trimmer line into
work area.
Trimming
(8 cm)
above ground
SCALPING
- The scalping technique
removes unwanted vegetation down to
the ground. Hold the bottom of the trim-
mer head about 3 inches (8 cm) above
the ground and at an angle. Allow the
tip of the line to strike the ground
around trees, posts, monuments,
etc.
This technique
increases line wear.
Scalping
MOWING
- Your trimmer is ideal for
mowing in places conventional
lawn
mowers cannot reach. In the mowing
position, keep the line parallel to the
ground. Avoid pressing
the head into
the ground as this can scalp the
ground and damage the tool.
Mowing
SWEEPING
- The fanning action of
the rotating line can be used for a
quick and easy clean up. Keep the
line parallel to and above the surfaces
being swept and move the tool from
side to side.
Sweeping
EDGING
- Adjust trimmer to the edg-
ing position (see TWIST AND EDGE
section).
Allow only the tip of the line
to make contact.
Do not force trimmer
line into work area.
Edging
Publicidad
