Publicidad
Idiomas disponibles
Idiomas disponibles
If Accessories
Needed
:
Installation
For 29" Existing
Cutout
Width
Opening
1. You must replace the actual side trims by new and
smaller side trims. These new side panels can be
ordered through a Sears Service Center.
2. Follow instructions supplied with your new side trim_
to replace the actual side trims with the new ones.
3. Check if the countertop
is prepared for 29" cutout
wide opening at page 7.
4. Install range as in the "installation
Without
Side
Panels" section above.
installation
With Backguard
A backguard
kit can be ordered
through
a Sears Service
Center.The
cutout
depth (21 3/4" (55.2 cm) Min.,
22 I/8" (56.2 era) Max.) needs to be increased
to24"
(61 cm) when installing a backguard
Installation
With End Panel
An end panel kit can be ordered
through
a Sears Servio
Center.
Installation
With Side Panel
A side panels kit can be ordered through
a Sears Servio
Center.
Install cabinet doors 31 " (78.7 cm) rain. apart so as not
to interfere with range door opening.
Leveling
the Range
ModeJs Equipped
with
Leveling
Device
Level the range after installation
in the cutout
opening.
I.
Open the range drawer. The leveling screws
control the height of the rear leg.
2.
Adjust the appliance legs as follows until the
underside of the cooktop (or cooktop glass)
surface is sitting level on the countertop
(Figure 8).
a.To adjust the front legs, use a wrench on
the leg base and turn counterclockwise
to
lower or clockwise to raise the range.
b.To adjust the rear legs, use a ratchet or a
nutdriver and turn the leveling screws
counterclockwise
to lower or clockwise to
raise the range.
3.
Check if the range is level by installing an
oven rack in the center of the oven and
placing a level on the rack (Figure 9).
4.
Take 2 readings with the level placed
diagonally in one direction and then the other.
Level the range, if necessary, by adjusting the
leveling legs.
5.
If the range cannot be level, contact a
carpenter to correct sagging or sloping floor.
Models
Equipped
with
Leveling
Leg_s
Level the range and set cooktop
height
before
installation
in the cut-out
opening.
I.
Install an oven rack in the center of the oven.
2.
Place a level on the rack (see Figure 9). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range, if
necessary, by adjusting the 4 leg levelers with a
wrench (see Figure 18).
3.
Taking care to not damage the countertop,
slide
range into cutout opening and double check for
levelness.
Jst Rear
Levelim
Leveling
Font
Leveling
Leg
LOWER
RAISE
Figure 8
J @
Figure 9
Publicidad
