Amate Audio Joker Active Systems Manual De Usuario página 20

Joker Active systems
3. MOUNTING AND PLACEMENT
For a proper installation of the acoustic cabinet systems, it is strongly recommended
to carefully read the following advices.
3.1. Placement
Fig.3. Flying placement
It is advisable to locate the subwoofer units on the floor as they can take advantage
of the so-called "floor-effect", thus increasing the response in the low frequencies.
If possible, place the subwoofers under the same acoustic axis used for the
satellites.
If the above option can not be carried out, then they should be placed in an
intermediate point between the left and right channels.
3.2. Tripod use
Fig.4. Full range cabinet with tripod
3.3. Full range cabinet with subwoofer
20
The Full Range cabinets should be located in a high
position (between two or three meters), slightly inclined to
the audience. If the loudspeakers are located too low, the
listeners at the end of the room will not hear a good sound
quality.
The JK26A+, JK46A, JK10A, JK12A, JK15A,
JK10MA and JK12MA models are equipped with a
tripod socket for use with a standard 35mm tripod.
Do not use the tripod on non-flat floors and be
careful not to raise the cabinet too high on the
tripod, as it may become unstable.
The JK12WA, JK15WA, JK18WA1 and JK18WA2
are equipped with a M20 Plate for a 35mm distance
rod. You can use it to place over the subwoofer the
models that are equipped with the tripod socket
(JK26A+, JK46A, JK10A, JK12A, JK15A, JK10MA
and JK12MA). Be careful not to use this system on
non-flat surfaces as it may become unstable.
Fig.5. Full range cabinet with subwoofer
Oct 2015
Amate Audio