Publicidad
Idiomas disponibles
Idiomas disponibles
16
Trouble Shooting
For safety, please observe the following points.
+ When trouble occurs, turn the power OFF immediately and
contact your dealer.
if smoke comes out of this unit or a bad odor or strange noise comes out, continuing
to use the unit can cause a fire or electrical shock. Turn the power OFF immediately,
unplug the power cord from the outlet and contact your dealer.
+ Absolutely do not remove the rear cover.
There are parts at high voltage inside, so touching them can cause an electrical
shock. Leave inspection, adjustment and cleaning of the interior to your dealer.
« Do not put anything inside.
lf liquid or a foreign object should get inside accidentally, immediately turn the power
OFF, unplug the power cord from the outlet and contact your dealer. Continuing to
usé the unit can cause a fire, electrical shock or breakdown of the unit.
If trouble occurs with the display unit, perform the following checks and take
the indicated action; if the trouble persists, please consult with your dealer.
"Symptom | Check | Action =
There is no display.
power cord / plug
Plug the power cord into the outlet correctly.
power switch
Press the power switch.
E
signal cable
Connect the signal cable correctly.
The power saving function
Release the power saving function by operating
might have acted (if so the
pilot LED will be yellow).
the mouse or keyboard.
For additional details please read the Operation
Manual of the hardware you are using.
Perform the desired settings and then save them
The image is too large or too | The mode is not registered.
-
by waiting 20 seconds or pressing the [1] "Exit" key.
small, or it is displaced from
the correct position.
The display color is abnormal. | Is there something that produces
| Remove the source of the magnetic field.
(Example) The color is
a magnetic field nearby?
Perform degaussing.
uneven or off-color.
{Examples) Television monitor,
Make sure your cable is correct.
The image distortion and or
another computer display unit,
Connect the signal connector correctly.
tilt is large.
speaker, etc.; was the
Try a different orientation.
'
orientation of the monitor
ee
perhaps changed while it was in
S
use?
The background of the image | The computer in use is Macintosh. | Press the operating keys [1] and [2] together at
is bright.
|
The signal output of the computer | the same time. You can then adjust this unit with
The background of the image | in use is improper.
the signal output of the computer. One more
is colored.
pressing or execution of recall can cancel this
The character gets partially
function.
distorted.
|
* This function is effective for a specified
The image is dark.
computer. If there is no problem in normal use,
[H]
en
avoid the use of this function.
Characters cannot be seen
Is the image signal level correctly | Check the video signal level from the computer
clearly; the image is too dark. | adjusted?
and adjust it in the correct direction.
Is the brightness or contrast
Adjust the brightness and contrast.
adjustment tumed all the way
down?
The screen size and
position do not change.
Is the input synchronization signal
within the operating range?
Check the video output mode from.the computer,
and select a mode within the display unit
operating range.
For details, please read the Operation Manual of
the hardware you are using.
The front panel keys fail to
Are 2 or more keys being
Operate only one key at a time.
operate.
operated at the same time?
Publicidad
