Publicidad
Idiomas disponibles
Idiomas disponibles
level ground, the top face of the mower deck (where the engine is mounted) should be approximately parallel to the ground.
Operation
NOTE: Ensure that the operator is suitably qualified to use a machine of this nature and that they have fully read and understood this manual -
they should be aware of all safety aspects relating to the safe use of the machine.
Prior to starting work the area to be cut should be checked for dangerous objects such as large stones,
wood, wire, glass etc. – hazardous objects should be removed from the area prior to operation with the machine. The location of unmovable
or natural hazards such as drain covers should be noted, or if necessary 'marked', to indicate to the operator that the area should either be
avoided or additional caution adopted whilst working around the hazard.
Operating Limits
Minimum / Maximum Ambient Temperature
Minimum / Maximum Altitude
Maximum Inclination
Maximum Speed
DO NOT OPERATE BEYOND OPERATING LIMITS, DAMAGE TO MACHINERY OR INJURY TO
Daily Checks
Before use each day, and with the engine switched off and keys removed, the following checks should be undertaken;
•
Blades - With the engine switched off and keys removed, the condition of the blades should be checked. Any damaged or missing
blades should be replaced immediately.
•
Engine - Fluid levels should be checked daily before use and topped-up as necessary. Ensure the air intake and screen grid are clear of
debris. Ensure engine is in good order and maintained as per engine manufacturer schedule.
•
Bearings - Ensure bearings are in good order and greased as per the maintenance schedule.
•
Belts - Ensure belts are in good order, free of debris, dirt and grease and do not have signs of damage e.g. cracking, frayed edges,
uneven wear.
•
Fuel - Ensure fuel is clean and free of dirt / debris. If necessary, check condition of fuel filter.
•
Hitch - Check condition of swivel hitch, and ensure this is attached securely to towing vehicle.
•
Tyres - Ensure tyres are free from damage and inflated to the correct working pressure for the conditions
•
at hand
Storage
For extended periods of storage, it is advisable that the machine be first cleaned thoroughly and fully lubricated. Any servicing and maintenance
should be undertaken prior to storage, and any worn components replaced.
NOTE: Fuel should be treated with a suitable fuel stabilizer before extended storage!
-15°C / +40°C
0 meters / 1500 meters *
20° in any direction
8km/h (5mph)
OPERATOR MAY OCCUR.
5
English
Publicidad
