Publicidad
Idiomas disponibles
Idiomas disponibles
Offsetting
If required the drawbar on the RM Series can be offset to the left or right or folded for storage.
The machine is offset by unscrewing the T-bar, moving the drawbar to the desired location, and the T-bar replaced in a suitable hole. The T-bar
must be tightened firmly to prevent movement of the drawbar and should be checked periodically for tightness.
THE DRAWBAR ANGLE SHOULD ONLY BE CHANGED WITH THE ENGINE OF BOTH MOWER
Starting Work
After ensuring all daily checks have been undertaken (see above), and with the engine throttle on idle setting start the engine by turning the
ignition key (if applicable) or pulling the recoil starter cord. Depending on the ambient temperature and engine temperature, choke may be
required. Once the engine is running and choke off, engage drive by increasing the engine throttle to maximum.
Forward Speed
The forward working speed will depend greatly on the working conditions and nature of the material being cut. Optimal speed will be in the
region of 3-8 km/h (2-5 mph).
Throttle Adjustment
Should you have trouble starting or stopping your mower, if, for example, the throttle cable has become bent or damaged, you may need to
adjust the throttle as follows; (Required: 1 Philips head screwdriver)
1.
Locate the throttle cable retaining bracket at the front of
the engine, loosen as shown using a Philips head
3.
With the throttle at full choke, pull the plastic part of the cable upwards, and tighten the retaining bracket when the choke lever just
AND TOWING VEHICLE SWITCHED OFF
RUN AT MAXIMUM THROTTLE AT ALL TIMES WHEN CUTTING
screwdriver
touches the plastic topped adjuster screw. Test for correct start / stop operation
2.
Set the throttle to FULL CHOKE, as shown below
7
English
Publicidad
