Lanaform AV-99C Manual Del Usuario página 7

Install the air purifier
Put the air purifier on a flat, solid surface so that
it does not vibrate or make a noise.
Please note
Leave a space of approximately 30cm at least
around the air purifier.
Make sure that the air inlets and exhaust are
never blocked.
Instructions
Connect the air purifier to
the "Lanaform Connect" app
The basic functions of the air purifier can be used
without the "Lanaform Connect" app. Addition-
al functions, such as displaying the temperature,
fine PM2.5 particle values and the percentage
of time remaining before the three-layer an-
ti-viral filter needs to be changed can only be
accessed from the "Lanaform Connect" app.
Switch on the air purifier
01 Follow the instructions in
the "Area of use" section.
02 Plug the device into the mains.
Position the power cable so
that nobody trips over it.
03 Press the Stop/Start button to
switch on the air purifier.
Note
The Wi-Fi symbol flashes.
To connect the air purifier to the "Lanaform
Connect" app:
• Make sure your smartphone is
connected to the Wi-Fi network.
• Download the free "Lanaform Connect"
app from the App Store (iOS) or
from Google Play (Android™).
• Launch the "Lanaform Connect"
app and follow the instructions.
• Click Connect a New Device or press
the + button at the top of the screen.
Follow the on-screen instructions to
connect the air purifier to your network.
Note
Depending on your smartphone's settings, the
internet connection or data transmission may
incur additional costs.
This only applies when you configure the air pu-
rifier for the first time.
Note
When it is first used, all the LEDs will light up
to begin with. The air purifier is set at the low-
est ventilation speed.
When the "Filter Reset" light beside the Stop/
Start button flashes, change the combined filter.
To do this, follow the instructions in the chap-
ter on "Changing the filter".
Ventilation speed
The air purifier has four ventilation speeds: I
(low), II (average), III (high) and IV (Turbo).
To move from one ventilation speed to another,
press the ventilation speed button.
The ventilation speed indicator as currently
configured will light up on the control panel.
UV lamp/Automatic
mode/Night mode
Press this button once to switch on the UV light.
Press this button a second time to switch on au-
tomatic mode. When the automatic function is
activated, the ventilation speed automatically
adapts to the ambient air quality. In other words,
the worse the air quality, the more the ventila-
tion speed increases automatically. Press a third
time to switch off the UV lamp, and a fourth time
to switch off automatic mode. Long press (3-5
seconds) to activate night mode. All indicators