Publicidad
All manuals and user guides at all-guides.com
IR remote control
The IR remote control buttons are similar to
those on the front panel. Place the two AAA
batteries in the remote control.
The remote control is only included for US.
For EMEA: You can purchase a remote
control by ordering part number TVR-
REMOTE-1.
To connect the remote control to the
recorder:
Menu
1. Press
on the front panel or right-click
the mouse and select Menu. The main
menu screen appears.
Display Mode Settings
2. Select
3. Check the recorder's device address value.
The default value is 255. The device
address is valid for all IR controls.
4. On the remote control press the
button.
5. Enter the device address value. It must be
the same as that on the recorder.
6. Press
OK
on the remote control.
USB mouse
The USB mouse provided with the recorder
operates all the functions of the recorder,
unlike the front panel, which has limited
functionality. The mouse lets you navigate and
make changes to settings in the user
interface.
Connect the mouse to the recorder by
plugging the mouse USB connector into the
USB port on the back or front panel. The
mouse is immediately operational and the
pointer should appear.
Web browser control
The recorder's Web browser lets you view,
record, and play back videos as well as
manage all aspects of the recorder from any
PC with Internet access. The browser's easy-
to-use controls give you quick access to all
recorder functions. See Figure 4 below.
To access the unit, open a web browser and
enter the IP address assigned to the recorder
TVN 11 Quick Start Guide
as a web address. In the logon screen, enter
the user ID and password.
Install the recorder web plug-in to see live
camera images.
The default values for recorder network
settings are:
•
DHCP: Disabled by default.
•
IP address - 192.168.1.82
•
Subnet mask - 255.255.255.0
•
Gateway address - 192.168.1.1
•
Server Port: 8000
•
HTTP Port: 80
•
RTSP port: 554
> Monitor.
Note: The following ports need to be
forwarded in the router in order to connect
properly: Server port and RTSP port.
Figure 4: Web browser interface
Device
Adding IP cameras
Camera already has a password
(activated):
The recorder automatically detects the camera
and checks its password to see if it is the
same as that of the recorder or if it is 1234. If it
is either, then the camera is successfully
added to the recorder.
If the camera password is not the same as
that of the recorder, nor 1234, it will be added
to the recorder but will appear as offline. You
can then change the camera password in the
Camera Setup
menu.
5
Publicidad
