Publicidad
Idiomas disponibles
Idiomas disponibles
e.
When drilling through holes, place a block
or wood behind the workpiece to prevent
ragged edges on the back side of the hole.
f.
If necessary, use a cooling lubricant when
drilling metal.
3.
Screw Driving
a.
Attach a screwdriver bit and set the
function selector to "
b.
Select a proper torque according to the
type and size of screw and material work
area.
c.
Pre-drill a hole of proper diameter and
depth before driving big screws into work
area.
d.
Hold the tool perpendicular to the screw
head and keep the bit tip well fitted into the
screw recess, then switch on the tool.
e.
Start at a low speed. Gradually increase
speed as the screw is driven in.
f.
Remove a jammed screw in the reverse
mode.
4.
Masonry Drilling
a.
Install a specialty bit designed for masonry
drilling and set the function selector to "
".
b.
Drill evenly keeping a uniform force on the
drill, don't force too much otherwise some
brittle materials are likely to be cracked.
c.
If you are experiencing a smooth,even flow
of dust, that indicates a good drill rate is
applied.
d.
Occasionally pull the bit out to clean dust
and chips if you are drilling a deep bore hole
into masonry.
MAINTENANCE
WARNING:
Only perform cleaning and maintenance work
according to these instructions!
All further works must be performed by a
qualified specialist!
WARNING:
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION: Make sure the
trigger is locked and battery pack is removed
before performing any procedure in this
section.
TO PREVENT SERIOUS INJURY FROM TOOL
WWW.SENIXTOOLS.COM
".
FAILURE: Do not use damaged equipment. If
abnormal noise or vibration occurs, have the
problem corrected before further use.
There are no user-serviceable parts in your
power tool.
If any of following conditions are found, stop
using it and send it to the authorized service
center for repair.
•
leaking, swollen, or cracked battery pack
•
loose hardware
•
misalignment or binding of accessories.
•
cracked or broken parts.
•
any other condition that may affect its safe
operation.
CLEANING
1. Clean dust and debris from air vents.
2. Keep handle clean, dry and free of oil or
grease.
3. Make sure the chuck is not clogged with
debris.
4. Remove stubborn dirt from housing with
high pressure air (max. 3 bar).
NOTE:
Do not use chemical, alkaline, abrasive or
other aggressive detergents or disinfectants
to clean this product as they might be harmful
to its surfaces.
TRANSPORTATION
1. Ensure the direction selector is in the cen-
ter lock position.
2. Only carry by its handle.
3. Protect from any heavy impact or strong
vibrations which may occur during trans-
portation in vehicles.
4. Secure to prevent it from slipping or falling
over.
STORAGE
1. Clean thoroughly as described above.
2. Store in a dark, dry, frost-free and well-ven-
tilated area that is inaccessible to children.
Store the battery within a temperature
range of 32°F - 77°F (0°C - 25°C).
3. Use original package for storage or cover
with a suitable cloth to protect it against
dust.
13 - EN
Publicidad
