Publicidad
Idiomas disponibles
Idiomas disponibles
EN
22
1.
After switching on, the device is in standby mode, the buzzer will make a
"beep" sound, the digital display will show the current ambient temperature,
the on/off button will be lit, the brightness will be at half level.
2.
Press the on/off button to turn on the device. The power button, plus button,
minus button, and timer button are all on. The heating indicator is on or off
depending on the ambient temperature. The initial temperature is 25 degrees;
when the ambient temperature is above 25 degrees, the heating indicator will
not light up. The heater does not heat, but when the temperature is below
25 degrees, it will light up. The heater heats up. Press the plus button for 3
seconds to switch the open window function on or off.
3.
Press the plus or minus buttons. The digital display starts flashing at 25 °C.
Set the target temperature. After setting, the device only displays the ambient
temperature. If the set temperature is at least 1 degree higher than the
current ambient temperature, the heater goes into heating mode and the
heating symbol lights up. When the set temperature is 2 degrees lower than
the current ambient temperature, the heating will stop and the heating icon
will be off. The adjustable temperature range is 10 °C - 50 °C.
4.
Press the timer button, the digital display will flash at 00 and the timer icon
will flash simultaneously with a timer setting of 1-24 hours. After the timer is
set successfully, the timer lamp will remain on; after the timer is completed,
the timer lamp will turn off. If you set the digital display to 00, the timer lamp
will turn off after 3 seconds. The setting is complete.
5.
After you make an adjustment for 30 seconds, the control panel lights up at
half level. If you press the minus button for 3 seconds, the panel light will
turn off and only the power button will light up at half level. Touch any button
again, and the digital display and all 4 buttons will light up. The open window
icon, heat indicator and timer indicator light up when the unit is in use but not
when it is off.
6.
If you switch the device on and off while the power supply is continuous, the
settings will be saved. After disconnecting and reconnecting the power supply,
the device will be reset to the factory settings.
You cannot perform any button
operation until you pick up and pull
out the control unit.
Publicidad
