Casals MT300EK Instrucciones De Uso página 10

ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
Stop the appliance by releasing the on/off
switch.
Unplug the appliance from the mains.
Close the lid.
Put on the protective cover.
Remove the remaining staples or nails from the
magazine after using the appliance.
Remove the battery from the appliance if you
are not intending to use the appliance during
an extended period.
Clean the appliance.
MAINTENANCE AND CARE
WARNING! Always unplug the machine before
carrying out work on it.
Checking the saw blade: deposits of resin
and glue on the saw blade cause inefficient
cutting. To avoid them, always clean the blade
immediately after use.
Inspect the mounting screws: regularly inspect
all the mounting screws and ensure they are
firmly tightened. Should any screw be loose,
tighten it immediately. Failure to do so could
put you at serious risk.
CLEANING
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
Never submerge the appliance in water or any
other liquid or place it under running water.
If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.
SUPPLIES
Supplies can be acquired from distributors and
authorised establishments (such as filters, etc.)
for your appliance model.
ANOMALIES AND REPAIR
Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
If the connection to the mains has been
damaged, it must be replaced, take the
appliance to an authorised technical support
service. Do not attempt to disassemble or
repair the appliance by yourself in order to
avoid a hazard.
SPECIFICATIONS:
Rated Power
Rated Voltage
No load speed
Oscillation Angle
Weight
Sound pressure level
Sound power level
Vibration
NB: These specifications are subject to change
without notice of purpose of improvement.
NB: By virtue of the conditions of fabrication
of this product, the maximum used power can
differ from that specified.
Measured sound level determined according
EN 62841-1.
The vibration emission level given in this
information sheet has been measured
according EN 62841-1 and may be used to
compare one tool with other. It may be used for
a preliminary assessment of exposure.
The vibration value during actual use of the
power tool can differ from the declared total
value depending on the way in which tool is
used.
300 W
230-240 V~
15.000 – 22.000 rpm
2,8 º
1,5 Kg
LPA = 89,2 dB
KPA = 3 dB
LWA = 100,2 dB
KWA = 3 dB
< 4,464 m/s2