Mac Mah KOLOR-BAR Modo De Empleo página 15


If you are using a controller with an XLR 5-pin DMX output, you will need to purchase
an XLR 5-pin/3-pin adaptor.

On the last device in the DMX chain, it is advisable to use a "DMX plug". (a 120 Ohm
1/4W resistor between pin 2 (DMX-) and pin 3 (DMX+) placed in a male DMX
connector).

Connect the fixtures one after the other: DMX output to DMX input of the next fixture.
The DMX cable must NEVER be a "Y" cable. The DMX-512 link carries a high-speed
signal. The cables used for this link must be of good quality and in good condition.

Each fixture must have a specific DMX address so that it can be controlled by the DMX
controller. (see table above).
7- Troubleshooting
Here are a few suggestions if you encounter problems with your

The appliance does not work at all.
o
Check the power cord and fuse.
o
Make sure that your plug is correctly plugged in.

The fixture does not respond or does not respond correctly to DMX commands.
o
Check your DMX cables
o
Check your DMX addressing
o
Try another DMX controller
o
Check that your DMX cables do not run close to high-voltage cables,
which could cause interference.

Does not react to sound
o
Check the selected operating mode
o
Check that there is no DMX cable connected to DMX IN
KOLOR-BAR
appliance
15