Jata JBSE2102 Instrucciones De Uso página 12

USE WITH THE CABLE
• Connect the USB cord terminal (5) at the bottom of the appliance and USB adaptor to the mains. Press the
switch (3) to start its operation.
USE IN SELF MODE, WIRELESS. CHARGING THE BATTERY
• Before using for the first time, it is necessary to charge the battery.
• Connect the cable terminal in the back side of the appliance and the USB cord next to the adaptor to the mains.
• The control panel (4) will light up indicating the battery charge level (a), while charging the charge indicator (d)
will blink and when the charge is complete, it will remain fixed.
• Total charging time is approx. 2 hours.
CUTTING GUIDE
• The shaver has 2 trimmers (A and B) (1-15 mm /16-30mm).
- Cutting guide A: You can select a cutting length from 1mm to 10mm, with 0.5mm per pivot point.
- Cutting guide B: You can select a cutting length from 11mm to 20mm, with 0.5mm per pivot point.
• Select the guide (A or B) (1-15 mm / 16-30 mm) according to the desired cutting length and insert it into the
top grooves of the cutter head.
• To choose the cutting length measurement, turn the selector (6) to the right to increase it or turn to the left to
decrease it.
TRIMMER-SHAVER JBCP3321
• The appliance is for cutting and doing the beard and the moustache and for the well-finished of the sideburns
and neck.
• The hair clipper may be used while connected to the mains with the cable or else autonomously (without
connecting to the mains).
USE WITH THE CABLE
• Connect the USB cord terminal (4) at the bottom of the appliance and USB adaptor to the mains. Press the
switch (3) to start its operation.
USE IN SELF MODE, WIRELESS. CHARGING THE BATTERY
• Before using for the first time, it is necessary to charge the battery.
• Connect the cable terminal in the back side of the appliance and the USB cord next to the adaptor to the mains.
• While charging, the charging indicator light (d) will blink and when the charge is complete it will remain steady
until disconnected from the mains.
CUTTING GUIDES
• The hair clipper is equipped with four cutting guides which allow for a accurate height of cut in four different
lengths (3-6-9 and 12 mm.)
• To assemble the chosen guide place it in the blade (fig. 1) and press the bottom flange of the guide to be
inserted (fig. 2).
DATA FOR BOTH DEVICES
LUBRICATION
• For the hair clippers to work correctly it is absolutely necessary to lubricate the blades with oil before each
use.
• Carefully pour a few drops of oil (8), which is provided, between the teeth of the blade, or if you have run out,
with another high quality, acid free oil.
• Turn the hair clippers on for a few seconds and clean the excess oil off with a cloth.
TRIMING BEARD
• Always remember you must begin with the cutting guide set to the longest cutting position before setting it in
the lower position.
• Start by cutting from the down side of the chin and moving the clipper with soft movements upwards and
outwards.
• For the final touches and the edges always use the hair clipper without any guide.
REVIEW OF THE MOUSTACHE
• Comb the moustache downwards.
• Start with the guide in its longer position. Later you may use the shorter cutting guides.
12