PLEASE NOTE
Examine the shipment to ensure the unit and manual are included and inspect the
unit for any visible damage.
Immediately notify the carrier and/or the supplier about an incomplete shipment
or any damage as a result of inadequate packaging or mishandling.
3.3 Unpacking
Carefully remove the packaging material and unit from the carton.
PLEASE NOTE
If possible, keep the original packaging for the duration of the guarantee period in
the event a return is necessary.
3.4 Setup location requirements
In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfi l the following prerequisites:
•
Place the device on a fi rm and even work surface.
•
Choose the setup location in such a way that children cannot reach any hot surfaces
on the device.
•
The device is not intended to be installed in a wall or a built-in cupboard.
•
Do not use the device outdoors.
•
The device requires adequate air circulation (minimum distance 15 cm).
•
Do not set up the device in a hot, wet or extremely damp environment or near
fl ammable material.
•
The installation and assembly of this device in non-stationary setup locations (e.g.
on ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
3.5 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instruc-
tions must be observed for the electrical connection:
•
Before connecting the device, compare the connection data (voltage and frequency)
on the rating plate with those of your electrical network. This data must agree in
order that no damages occur in the device. If in doubt, ask your qualifi ed electrician.
•
The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fi re that is involved with this.
•
Make sure that the power cable is undamaged and has not been installed under the
ice maker or over hot or sharp surfaces.
•
The electrical outlet must be protected by a 16A safety cut-out switch.
•
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installati-
on checked over by a qualifi ed electrician. The manufacturer cannot be made respon-
sible for damages that are caused by a missing or damaged protective conductor.
CASO SJW 600 XL
DE
EN
FR
IT
ES
NL
RU
SV
25