auronic AU3178 Manual De Instrucciones página 28

3.4 Temperature setting
1. Press or to set the desired temperature.
2. Press to increase or
remembered if you do not press any buttons for 4 seconds.
ATTENTION!
◊ The temperature you see on the display is the current temperature of the compartment on
the inside of the product. It takes a while until the desired temperature is reached.
3.5 Switching between cooling modes
While the product is on, press
mode). The factory setting is MAX.
3.6 Temperature unit settings
1. Turn off the product.
2. Press for three seconds until
3. Then press or
3.7 Battery protection mode
1. While the product is on, press
2. Then press to select protection mode H (High), M (Medium) and L (Low). The factory
setting is H.
3.8 Voltage reference
Input
Mode
L
M
H
Note
◊ The voltage is a theoretical value, there may be a deviation in different scenarios.
◊ H should be set when the product is connected to auto power. M or L should be set when the
product is connected to a portable battery or other backup battery.
3.9 Reset
1. Turn off the product.
2. Press for three seconds until E1 appears.
3. In E1 mode: press
28
to decrease. The set temperature will automatically be
to switch between MAX (fast cooling) and ECO (energy-saving
E1 appears and continue to press
to select Celsius or Fahrenheit. The factory setting is Celsius.
for three seconds until the display flashes.
DC 12V
Cut-off voltage
8.5V
10.1V
11.1V
simultaneously until the display shows 888.
Turn-on voltage
10.9V
11.4V
12.4V
until E5 appears.
DC 24V
Cut-off voltage
21.3V
22.3V
24.3V
Turn-on voltage
22.7V
23.7V
25.7V