Silk’n SILKYAIR FLEX SIF005 Manual De Usuario página 11

7.1 Internal cleaning
EN
• With this function, the motor operates in reverse direction to draw air from
the air outlet
• Use this function every 2 weeks or when the cleaning icon ( )
Overuse may damage the product.
1. Connect the mains cord
2. Within 10 seconds, press and hold the speed button
at the same time for about 3 seconds to activate the internal cleaning mode.
The product operates in reverse direction for about 10 seconds before stopping
automatically.
3. If necessary, repeat step 2 to activate this function again.
You can only activate this function 3 times at a time. To enter the internal cleaning
mode again, you must unplug the product and start over again.
7.2 Cleaning the filter
To avoid the accumulation of dust inside the product, clean the filter cage and filter mesh
every 2 weeks.
1. Turn the filter cage
2. Slide the filter cage downwards along the mains cord
3. Clean the filter cage and filter mesh
4. Attach the filter cage back onto the product. Turn it to the right to lock it in place.
8 Storage
All parts must be completely dry before being stored.
• Store the product in a clean and dry place, avoiding heat and direct sunlight.
• Store the product so that it is not accessible to children.
9 Troubleshooting
Some problems may be caused by minor faults that you can fix yourself. To do so, follow
the instructions in the following table. If it is still not possible to resolve the problem,
contact customer service. Do not repair the product yourself.
Fault
The product does
not operate.
The hair is singed.
Error message E01
or E04–E10 shows in
the display.
Error message E02
or E03 shows in the
display.
11
and clean the internal parts of the product with cool air.
1
to an easily accessible mains socket.
16
to the left until it detaches from the product (see step 1 in Fig. E).
13
15
Possible cause and solution
• Make sure the product or mains cord
the mains cord is properly connected to a mains socket.
• The product overheats. Unplug the product and wait until it
has completely cooled down before using it again.
• The selected operating temperature is too high. Select a lower
temperature.
• There is an internal error. Contact customer service for
support.
• The voltage is either too low or too high. Connect the
product to an appropriate mains socket.
and temperature button
5
(see step 2 in Fig. E).
16
with a soft cloth or brush.
illuminates.
9
is not defective, and
16
6