Publicidad
Idiomas disponibles
Idiomas disponibles
CHARGING PROCESS
1.
Firstly connect the charger cable to the hoverboard.
2. Then, connect the charger to a 240V electric supply. The red light on the charger will turn red
indicating that it is charging, and the light on the hoverboard will go from red to yellow. Please note
that if you do not connect the hoverboard to the charger, it will block itself after 90 seconds and it
will not charge.
3. 2 or 3 hours later, the charger display light will go from red to green, indicating the battery
is completely charged. This green light will only be lit for 30 seconds, and it will then turn off
automatically to avoid overcharging.
4. Disconnect the charger from the electric supply and then from the hoverboard once the charging
process is complete and the charger display light is off.
5. The hoverboard it is now ready to be used.
FACTORS TO BE TAKEN INTO ACCOUNT DURING THE CHARGING PROCESS
-
Please ensure that the charger port is dry
-
The battery must be charged when the battery light is red
-
After each charge, the charger must be disconnected from the electric supply and the
hoverboard. Should it had not been disconnected from the electric supply in the last charge,
and before charging your battery again, disconnect the charger from the electric supply and
the hoverboard completely and wait for 2 minutes. Switch off the hoverboard and ensure it is
unplugged from charging. This is to reestablish the safety function of the automatic cut-off of
the charger. This function protects your hoverboard from overcharging.
-
If the hoverboard is on when you start charging, the screen led of the battery will go from red
to yellow, and the hoverboard will turn off after 10 minutes.
-
Keep and charge the battery as indicated to avoid damaging it. Charging time is 2-3 hours.
-
Keep the charging area dry and clear.
Puerto de carga
Botón de encendido
55
INSTRUCTION MANUAL HOV-10
EN
Publicidad
