Publicidad
Idiomas disponibles
Idiomas disponibles
are connected and properly used. Use of dust collection can reduce dust-related hazards.
GENERAL SAFETY RULES
•
Do not attempt to touch or stop the blade when it is rotating.
•
A moving blade can cause severe injury. Maintain proper control of the machine with both hands
until the blade has completely stopped rotating.
•
Replace any blade that has been damaged. Always make sure blade is installed correctly and
securely fastened before each use.
•
Use only the manufacturer's replacement GREENCUT blade. Do not use any other cutting attachment.
•
Never cut any material over 13mm diameter.
•
Your Brushcutter is fitted with a harness. Carefully adjust the harness to fit comfortably and help
to support the weight of the machine at your right side.
•
Identify the Quick Release mechanism and practice using it BEFORE you start using the machine. It's
correct use may prevent serious injury in the case of an emergency. Never wear additional clothing
over the harness or otherwise restrict access to the quick release mechanism.
•
Cover the blade with the blade protector before storing the unit, or during transportation. Always
remove the blade protector before using the unit. If not removed, the blade protector could
become a thrown object as the blade begins to turn.
•
Exercise extreme caution when using the blade with this unit. Blade thrust is the reaction that may
occur when the spinning blade contacts anything it cannot cut. This contact may cause the blade to
stop for an instant, and suddenly "thrust" the unit away from the object that was hit. This reaction
can be violent enough to cause the operator to lose control of the unit. Blade thrust may occur
without warning if the blade snags, stalls, or binds. This is more likely to occur in areas there it is
difficult to see the material being cut.
•
For cutting ease and safety, approach the weeds being cut from the right to the left. In the event
an unexpected object or woody stock is encountered, this practice could minimize the blade thrust
reaction. Both hands must be used at all times to control this product.
WARNING
Some regions have regulations that restrict the use of the product. Check with your
local authority for advice.
RESIDUAL RISK
Even when the product is used as prescribed, it is still impossible to completely eliminate certain residual
risk factors. The following hazards may arise in use and the operator should pay special attention to
avoid the following:
•
Injury caused by vibration. Always use the right tool for the job, use designated handles and restrict
working time and exposure.
•
Exposure to noise can cause hearing injury. Wear ear protection and limit exposure.
•
Kickback can occur when using the brushcutter. Ensure proper control by using both hands on the
designated handles.
91
EN
Publicidad
