LG WM3050C Serie Manual De Instrucciones página 28

28 MAINTENANCE
MAINTENANCE
Care
Care after wash
After the cycle is finished, wipe the door and the inside of
the door seal to remove any moisture Leave the door open
to dry the washer tub interior Wipe the body of the washing
machine with a dry cloth to remove any moisture
_A WARNING ....
} • Unplug the washer before cleaning to avoid the risk of
electric shock. Failure to follow this warning can cause
serious injury, fire, electric shock or death,
• Never use harsh chemicals, abrasive cleaners, or
solvents to clean the washer. They will damage the finish
• Do not use volatile substances (benzene, paint thinner,
i alcohol, acetone, etc,) or detergents with strong
i chemical components when cleaning the washing ,
} machine. Doing so may cause discoloration or damage to
[ the machine, or it may cause a fire.
Care in cold climates
6 6J _ 6:!
Fellow the instructions for storing the washing machine if you
de net use it for an extended period of time in cold climates
below freezing point
1
Turn off the faucets connected with the water lines
2 Unscrew the water lines from back of the washer
3 Empty any water out of the water lines
4 J®"
Press \ 9.
5 Open the door and add 1 gallon (38 L) of nontoxic
recreational vehicle (RV) antifreeze to the empty washer
tub. Close the door
6 Press @for draining
and spinning
7 Press ,_!1.
- Drain the water from the washing machine for 1 minute
Not all of the RV antifreeze will be expelled
8 Press _O_ to turn off the washing machine and pull out the
power plug.
9 Dry the tub interior of the washer tub with a soft cloth, and
close the door.
, D
10
Press down hard on the disengage button and pull out the
detergent dispenser drawer.
11 Drain the water from the detergent dispenser drawer and
dry out each compartment
12
Store the washing machine in an upright position
:-@ NOTE -_
• To remove the antifreeze after storing the washing
machine, add detergent to the dispenser, and run one
;; cycle Do not load any laundry at this time.
1
Turn off the faucets connected with the water lines
2 Pour hot water on the frozen faucets to thaw the water
lines and pull them out
3 Immerse the water lines in hot water to thaw them.
4 Connect the water lines with the water inlets of the
washing machine and faucets.
- See page 14, Connecting the water lines for details.
5 Turn on the faucets
6 FO" Press, 9
7 Turn
_)_ to Rinse+Spin.
8 Press \11
- Verify the water fills properly.