Publicidad
Idiomas disponibles
Idiomas disponibles
When
Leaving
Unattended
or Stopping
Pressure
Washer
1.
Place rocker switch in OFF position.
2.
ALWAYS point spray gun in a safe direction,
push red button and squeeze spray gun trigger to
release retained high water pressure.
WARNmNG
The high pressure stream of water that
this equipment produces could cut through
skin and its underlying tissues, resulting in
{_---_---_} s erious injury and possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which
couBd result in serious injury.
o Keep high pressure hose connected to pump and spray
gun while system is pressurized.
ALWAYS point spray gun in safe direction, press red
button and squeeze spray gun trigger to release high
pressure, every time you stop engine.
How to Use Accessory
Tray
The unit is equipped with an accessory tray with
places to store your spray gun, nozzle extension, high
pressure hose and selector nozzle.
1.
Place spray gun in wide groove on accessory tray
as shown. Pull rubber strap tight around spray gun
and place hole in strap over tab on accessory tray.
2.
Place nozzle extension in narrow groove on
accessory tray. Pull rubber strap tight around
nozzle extension and place hole in strap over tab
on accessory tray.
3.
Insert selector nozzle in hole provided on front of
accessory tray.
.
How to Use Selector
Nozzle
Place one end of high pressure hose in groove at
top of accessory tray and wrap high pressure hose
around hooks as shown.
J
/
The selector nozzle allows you to switch between five
different spray pattern nozzles. Spray patterns can be
changed while pressure washer is running once spray
gun trigger safety lock is engaged. The spray patterns
vary as shown below.
Z_ WARNING
The high pressure stream of water that
this equipment produces could cut through
skin and its underlying tissues, resulting in
serious injury and possible amputation.
, NEVER change spray patterns without the trigger locked
on the spray gun.
, DO NOT twist selector nozztewhile spraying.
Follow these instructions
to change
nozzle
patterns:
1
Se}ect desired spray pattern:
•
MAX - For stubborn or hard to reach surface
such as second story surfaces, paint removal,
oil stains rust removal or other stubborn
substances (tar, gum, grease, wax, etc.).
•
GENERAL - For most aH purpose cleaning
such as home siding, brick patios, wood decks,
driveways and sidewalks, garage floors, etc..
DEUCATE o For gentle cleaning of cars/trucks,
boats, RV's. patio furniture, lawn equipment, etc_
FLUSH - For quick high flow clean up and
long reach cleaning of second story siding and
windows.
SOAP - For general soap applications or
to launch soap to second story siding and
windows, cleaning of second story siding and
windows.
14
Publicidad
