Publicidad
Idiomas disponibles
Idiomas disponibles
Intended use
This device is only to be used as a grinder, sander,
for work with wire brushes and for cut-off machin-
ing of metal, concrete, stone and similar materials
without the use of water. Use only original Würth
accessories. Any other use or use outside this scope
is considered improper use.
The user is solely responsible for damage
resulting from improper use.
Device elements (Fig. I/II)
1 Trigger switch
2 Switch-on inhibitor
3 Additional handle with vibration damping
4 Cut-off safety hood clip*
5 Safety hood
6 Spindle
7 Autobalancer support flange
8 Spindle locking knob
9 Rubber plate with abrasive sheet*
10 Cup brush*
11 Abrasive wheel*
12 Quick-clamping nut (Q-Nut)
13 Locking lever
* Accessory, not included in the scope of delivery
Start-up
attention !
Before initial use, check that the specifications of
your mains power supply correspond to the mains
voltage and mains frequency indicated on the
name plate.
Attaching auxiliary handle
Caution !
Risk of severe injuries.
Work only with the additional handle
¾
[3] attached!
▸
Screw in the auxiliary handle firmly on the left-
hand or right-hand side of the machine.
Attaching the safety hood (Fig. II)
Caution !
Risk of severe injuries.
For safety reasons, use only the safety
¾
hood intended for the respective
grinding wheel!
Use only attachments with a
clearance of at least 3.4 mm to
the safety hood.
Safety hood for grinding
Intended for use in work with roughing discs, mul-
ti-disc grinding wheels, diamond cut-off wheels.
▸
Press and hold the locking lever [13].
▸
Push the safety hood [5] onto the spindle neck as
shown.
▸
Adjust the position of the safety hood to the posi-
tion of the hand on the machine. Turn the safety
hood until it is in the desired position.
The closed side of the safety hood must be facing
3
towards the operator.
▸
Release the locking lever and turn the safety hood
until the locking lever audibly engages.
▸
Check that the dust extraction hood is secure: The
lever must be engaged and it must not be possible
to turn the safety hood.
Cut-off safety hood clip for cut-off grinding
Intended for use with cut-off wheels, diamond cut-off
wheels.
▸
With the cut-off safety hood clip [4] attached, the
safety hood becomes a cut-off safety hood.
Attaching grinding wheel
Warning !
Risk of severe injuries.
Pull the mains plug out of the plug
¾
socket before all tooling operations.
The machine must be switched off
¾
and at a standstill.
Locking spindle
▸
Press in the spindle locking knob [8] and turn the
spindle by hand until the spindle locking knob
audibly engages.
21
Publicidad
