Dremel MS20 Instrucciones De Funcionamiento Y Seguridad página 10

DM 2610Z03287 05-13_DM 2610Z03287 05-13.qxp 5/24/13 8:09 AM Page 10
Assembling Base Station for
Stationary Use
Disconnect the plug from
W RNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting
the tool accidentally.
Mount the Base Station to a flat working
surface of a comfortable height. Insure that
the working surface is of a thickness that can
accept the clamps and/or mounting screws.
Mounting the Base Station to an unstable
surface can invite an accident.
1. Position the saw station at the front edge
of the flat work surface the saw station will
be clamped to.
2. Unthread the provided clamps to ensure
they will be able to clamp to the work
surface. Slide the flat edge of the clamp
into the slot in the bottom of the saw
station and tighten the clamp to prevent
the saw station from shifting during use,
Fig. 6.
The base can be permanently secured to a
work bench with regular screws through
the two holes located on the top of the
base, Fig. 7.
3. Feed the Moto-Saw cord through the hole
in the center of the base, Fig. 8.
4. Lower the Moto-Saw to the saw station
surface then push forward until it clicks
into the locked position, Fig. 9.
FIG. 8
FIG. 6
FIG. 7
10
FIG. 9