Descargar Imprimir esta página

GET RX1 PRO Guia De Instalacion página 6

Ocultar thumbs Ver también para RX1 PRO:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 18
5.
Insert the GET RX1 Pro ECU
into the rubber support and
connect it to the OEM connector.
Make sure the connectors are
properly plugged in, and the
retainer clip is fully engaged.
6.
Install GET Map Switch by
following the instructions in "Map
Switch Installation" Section in
GET RX1 Pro manual.
ATTENTION:
For Honda CRF 250 R 2018-2021 and for Honda CRF
450 R 2018-2020, the OEM traction control and the
OEM map switch push button will not work when
GET RX1 Pro ECU is installed. Please only use GET
Map Switch (included in the kit) and GET LC-GPA
module (sold separately). For Honda CRF 450 R
2019-2020 the OEM mode button (blue one) can be
used to manage GET LC-GPA when installed.
7.
If included in the kit, install
GET WiFi-COM by following the
procedures in the dedicated manual.
8.
Re-install the seat and the
front side panels.
EN
6

Publicidad

loading

Productos relacionados para GET RX1 PRO