Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 2: FABRIC ATTACHMENT
1. Place the projection surface with the
projection side down on a clean surface.
Make sure that the surface and the
background are not dirty. Carefully po-
sition the frame.
with the fl at side down in the centre of
the projection screen surface. If there is
an ultrasonic weld in the viewing area
of the projection screen surface, please
mount the projection screen surface in
such a way that this seam is in the upper
portion of the screen.
2. Now fi x the projection screen surface
in place with the pre-assembled Velcro
strips to the frame.
Proceed as follows:
Start on a horizontal side and pull the
projection screen with the Velcro strip
to the back of the frame. Make sure that
the frame is square and the projecti-
on screen surface reaches the corners
(Fig. 11).
Now carry out these steps on the oppo-
site side and try to stretch the projecti-
on screen fabric as far as possible while
you fi x it with the Velcro strips.
Fig 9
Fig 10
Abb. 10
Fig 11
8
Publicidad
