Publicidad
Idiomas disponibles
Idiomas disponibles
2in1 Rechargeable Table Lamp Use instructions
Once the charging is complete, the LED will change color to blue. A complete charge takes about 5 hours. The
charging time may vary based on the USB source's power. Gently disconnect the cable from the charging port.
Do not pull the power cable; instead, gently grasp the plug.
Usage Instructions
Place the lamp on a flat and stable surface. To turn on the product, touch the touch switch. Touch the switch
again to change the light tone among the three warm, cold, and neutral variants. On the fourth touch, the lamp
will turn off. To adjust the light intensity, press and hold the switch until you achieve the desired brightness.
To use the lamp resting on a wine bottle, follow these steps:
Carefully place the lamp upside down on a flat surface, keeping the diffusion lens facing upward.
Gently unscrew the bracket from the lampshade and position the bottle adapter to align the threaded hole with
the lampshade connector.
Verify the correct alignment of the charging port hole on the diffusion lens.
Screw the bottle adapter until it stops while securely holding the lampshade. Do not overtighten to avoid dama-
ging the diffusion lens.
Place the lamp on top of the bottle.
Warning: when using the lamp on a bottle, ensure that the bottle is either still sealed and full or filled
with water to increase stability and prevent tipping.
Cleaning
Before cleaning, disconnect the lamp from the power source.
Clean the product with a dry cloth; do not use solvents or abrasive products.
Technical Data
2W, IPX4, 110 lm, 3000/3500/4500 K
Rechargeable lithium battery 3.7V - 2000 mAh
USB power: 5V
In the pursuit of continuous improvement, Beper reserves the right to make modifications and improve-
ments to the product without prior notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
10
Publicidad
