Publicidad
Idiomas disponibles
Idiomas disponibles
Lock the spindle and
assembling metal cutting disc/
abrasive cutting disc /grinding
disc
NOTE: Press and hold
the spindle lock button
to lock the spindle.
NOTE: Make sure that the
metal cutting disc/
abrasive cutting disc /
grinding disc is assembled
firmly.
WARNING! Before any
work on the machine
itself, remove the battery
pack.
Lock the spindle and removing
metal cutting disc/abrasive
cutting disc /grinding disc
Adjusting Wheel Guard for
grinding/cutting
Note: Remove the battery
pack before making any
changes to the tool.
For work with grinding
or cutting discs, the
protection guard must be
mounted. Use the correct
type of disc for your
application.
If the power tool is
intended to perform any
cut-off operations, a guard
specific for this operation
must be installed.
Installing the Battery Pack
WARNING: Before
inserting the battery
pack, make sure that the
ON/OFF Switch is in OFF
position.
WARNING: When
replacing the battery
pack, do not insert the
battery pack until the metal
cutting disc/abrasive
cutting disc /grinding disc
comes to a complete stop!
OPERATION
Cordless Mini Cutter
Using On/Off Switch
Note: Depress the On/Off
switch forward to lock-on
button. Your switch is now
locked on for continuous
use.
Hand grip areas
Rough Grinding
See Fig. B
WARNING! Never use a
cutting disc for rough
grinding applications. This
can cause bodily damaged
by using the tool for wrong
applications.
Cutting
WORKING WITH THE MINI
See Fig. C
CUTTER
1. Always start at no load to achieve
maximum speed then start working.
2. Do not force the disc to work faster,
reducing the Disc's moving speed means
longer working time.
3. Always work with a 15-30 angle between
disc and workpiece when grinding. Larger
See Fig.
angles will cut ridges into the workpiece
D1,D2,D3
and affect the surface finish. Move the
tool across and back and forth over the
workpiece.
4. When using a cutting disc never change
the cutting angle otherwise you will stall
the disc and mini cutter motor or break the
disc. When cutting, only cut in the opposite
direction to the disc rotation. If you cut in
the same direction as the disc rotation the
disc may push itself out of the cut slot.
5. When cutting very hard material best
results can be achieved with a abrasive
cutting disc.
6. When using a abrasive cutting disc it will
become very hot. If this happens you will
See Fig. E
see a full ring of sparks around the rotating
disc. Stop cutting and allow to cool at no
load speed for 2-3 minutes.
7 . Always ensure the workpiece is firmly held
or clamped to prevent movement.
See Fig. F
See Fig. G
See Fig. H
See Fig. I
13
EN
Publicidad
