Linsar E0B/RVC-VS-ECOM Manual Original página 107

- Do not operate the power unit using an external timer or
separate remote-control system.
- The power cable of the power supply unit cannot be replaced. If
the cable is damaged, the power supply unit must be scrapped.
- Do not immerse the product, the plug-in power supply or the
connection cable in water or other liquids.
- Never touch the power unit with wet/damp hands.
- Never pull the power unit out of the socket by thecable; always
pull it out by the plug.
- Do not operate the product if it has visible damage or if the
connection cable or the plug-in power supply unit is defective.
- Damaged products or power units must be replaced by the
manufacturer, their after sales support or a similarly qualified
person. Repair by an unqualified person increases the safety risk
for the user.
- Do not open the product and the housing of the plug-in power
supply unit, but leave the repair to specialists. Contact the
service address indicated on the warranty card. Liability and
warranty claims are excluded in the event of repairs carried out
independently, improper connection or incorrect operation.
- When repairing, only use parts that correspond to the original
device data. There are electrical and mechanical parts in this
product to protect you from danger sources.
- Keep the product, the plug-in power supply and the connection
cable away from open flames and hot surfaces.
- Lay the cable of the plug-in power supply so that it does not
become a tripping hazard.
- Do not bend the cable of the plug-in power supply and do not
lay it over sharp edges.
107